Electronics Forum | Tue Jan 24 20:05:24 EST 2017 | erici
we have one dot matrix printer and i would like to connect it to the TP9 machine. The parameters settings for printer is "protected" so i cannot assign the printere to the machine. How do i "unprotect" the parameter to allow me to make changes?
Electronics Forum | Tue Jun 11 14:45:59 EDT 2002 | stefwitt
I can not find a F4G in Fuji�s equipment list. Siemens has a F4 ( flexible fine pitch machine ) and also a GII ( glue dispensing machine ), which both would make sense to add to your equipment list. Machines are �connected� together with their conve
Electronics Forum | Fri Apr 07 09:26:36 EDT 2006 | engguy
This is common with older Fujis. The machine is trying to download production data to the host(MCS?) If the cable is not connected or if the MCS is off, the machine will randomly freeze at the end of prod. Either solve those issues or change the m
Electronics Forum | Tue Sep 22 13:51:23 EDT 2020 | makersan
Hi If anyone uses a label feeder in yamaha ys12f model p & p machine, Can it tell you how to connect the machine with the label feeder? The label feeder we will use is in the link below. https://label-feeder.com/wp-content/uploads/2015/07/Product-
Electronics Forum | Sun Jun 25 00:33:13 EDT 2000 | Robertsam
I had problembs with taping the signal to on the buzzer with machine tower light.However I try to connect parrallel to the light but the control board which connected to the light malfunction after 1/2 hour.The tower light is trigger by the ground s
Electronics Forum | Thu May 27 13:18:30 EDT 2004 | swilson
Hello does anyone have a schematic or service manual on setting up a foam fluxer on the 650C wavesolder machine. I am concerned with the two pumps in the rear of the machine what are the connection for on the pumps. I do have the manuals, but they do
Electronics Forum | Sun Mar 03 07:22:03 EST 2002 | rkey
Hi, We've got one CSM60 and one CSM60V! After searching for a long time i've found the CSM Toolbox (/10) for UFO FIles !! Now i want to connect those machine's to a PC but i've tried everyhing but it doesn't work !! Does someone have experiance wi
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
Electronics Forum | Mon Oct 29 15:57:44 EDT 2012 | ngotranbestek
Hi Michel CP642 ont interface with RS-232. All machine CP6 or IP3,..will connect to DigiBox ( RS232 Port)and connnect to Computer have Sofware Flexa.
Electronics Forum | Sun Jan 27 11:28:42 EST 2013 | mdang
Could anyone help to connect a FUJI CP42 machine to a conveyer with stanard SMEMA? CP42 has 2 wire cable and small female connector label SMEMA (Not fit with stanard SMEMA). Thank you for all your help, -Michael