Electronics Forum | Fri Feb 15 07:52:27 EST 2008 | lococost
Dear SMTnetters, I've been told to have a look at finding a machine that could mill the leads of all PTH components to a certain height on an assembeled and soldered PCB. PCBs should be inserted in one side of the machine and come out milled on the
Electronics Forum | Mon Feb 18 09:48:40 EST 2008 | lococost
Thank you Mr Fish and Operator. All these machines seem to be manually controlled though. At least it gives me an idea of what is in the market.
Electronics Forum | Tue Feb 19 14:52:04 EST 2008 | dphilbrick
You also need to understand when using something like a Q Cutter you should resolder the board after you cut! Your alternative is to get someting that when you put your part in it cuts and clinces the part. Contact Systems makes machines that present
Electronics Forum | Tue Feb 19 14:02:56 EST 2008 | scooter
I have done this in a past life. In my mind this is a step backwards. If all of your parts are placed by hand it will work.You will need to cut at the top of the solder to keep the leads form bending If any parts are auto inserted you will need to c
Electronics Forum | Tue May 17 03:48:51 EDT 2005 | Base
YV100, easy... YV112 uses a dual work-area, dual gantry machine in which the gantry does X and the PCB-table does Y movements. Also each gantry can only work on one PCB work-area and can pick form only one side of the machine. Basically you have two
Electronics Forum | Mon Dec 20 10:33:39 EST 2010 | kahrpr
Durstone is relatively easy to machine. use a 4 fluted end mill and keep the speed down on the mill. sounds like your RPMs are to high.
Electronics Forum | Tue May 07 03:56:30 EDT 2013 | pavel_murtishev
Davef, Thank you. I wonder if you have ever faced with concrete layer thickness selection for SMT shops? All I have found refers to metal treatment shops (primarily milling & drilling). 6" concrete is thick enough for them to stabilize milling machi
Electronics Forum | Thu Dec 26 13:02:15 EST 2002 | MA/NY DDave
Hi Again, As I was thinking about this, I remembered another unconventional way that I was told about from one of the starters of this technology. Now I don't think anyone would use this technique anymore, yet here it is: Press Cutting and Pushing
Electronics Forum | Fri Mar 27 07:45:38 EST 1998 | Matt P.
I am specing out a desk-top type SMD proto-typing and reworking machine for low volume application. Capabilities to 10 mill pitch on a 160 lead quad pack are required. Any suggestions? Thanks, Matt
Electronics Forum | Mon May 21 09:00:19 EDT 2012 | mosborne1
Try switching to a polymer nozzle. Your machine manufacturer may sell them on any machine shop can mill you one. Also check to see if your pick and place had a puff off function. Some older machines have a mechanical adjustment on the mac valve used