Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Fri May 13 09:46:01 EDT 2005 | pr
Sales pitch aside, why limit yourself to yamaha?
Electronics Forum | Tue May 17 10:45:41 EDT 2005 | Sam Ho
Thanks for your advise!!
Electronics Forum | Thu May 12 10:35:32 EDT 2005 | Sam Ho
i would like to know which model of yamaha p&p machine is more stable in the SMT process
Electronics Forum | Thu May 12 10:39:04 EDT 2005 | Sam Ho
i would like to know which model of yamaha P&P machine is more stable in the SMT process
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Fri May 13 10:52:10 EDT 2005 | Sam Ho
i want to know YV112 and YV100, which one is better and more stable.
Electronics Forum | Thu May 12 15:35:16 EDT 2005 | msivigny
Hi Sam, I'm afraid I can't answer this question in this forum. I'm sure many people would like to know which model or brand is better than the next, but even if we had the data, we would not share it. Our independent measurement services and associat
Electronics Forum | Tue May 17 03:48:51 EDT 2005 | Base
YV100, easy... YV112 uses a dual work-area, dual gantry machine in which the gantry does X and the PCB-table does Y movements. Also each gantry can only work on one PCB work-area and can pick form only one side of the machine. Basically you have two
