Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
Electronics Forum | Sun Aug 04 04:51:23 EDT 2019 | alexeyzb
3D machine give you more opportunities. Now i works with YAMAHA, but i only to start the inversigation and can't say objecive opinion. Before i worked with KOH YOUNG - good machine. Also i heard that Omron good machine too. I reccomend to make two PC
Electronics Forum | Mon Sep 23 07:40:17 EDT 2019 | spoiltforchoice
A fair price.... well its the feeders that retain value. I know if you were to sell an Essemtec distributor a machine with say 10 banks of CLM feeders that old, they would give you perhaps only £10k. Refurb CLM feeders are ~£3k gbp (or about 1/2 of n
Electronics Forum | Mon Feb 04 16:29:39 EST 2008 | tonyamenson
I have been trying to eliminate the troublesome tubed parts in our SMT process but because we are a high mix/low-medium volume we still have to deal with it sometimes. However, the ones I can fix I'm working on. The next step in my war against tubes
Electronics Forum | Mon Aug 27 22:16:03 EDT 2012 | ilanhovan
Hi, my supplier is using the same Aqueous machine to clean the boards for 2 different customers. My product uses the chemistry of leaded clean flux meanwhile the other product uses the chemistry of lead free with no clean flux, however that product r
Electronics Forum | Mon Mar 18 08:48:58 EDT 2024 | spoiltforchoice
200 unique components across an entire range is nothing, Were we all so lucky we would all leave the inventory permanently loaded on the line. The Manncorp machines are probably your cheapest solution new. These chinese machines with western input
Electronics Forum | Wed Dec 14 12:48:21 EST 2005 | grantp
Hi, A second hand TP9-2U MYDATA could be picked up very low cost, however it will only load a single component at a time, which could be ok for your jobs. However if your running 0402, I am not sure if that model will do it accurately. Your machin
.gif)
winsouce.jpg)