Electronics Forum | Thu Oct 16 15:23:09 EDT 2014 | davef
Search yamaha+motor here: http://www.smtnet.com/parts/
Electronics Forum | Thu Oct 16 04:46:46 EDT 2014 | haiae
I'm looking for a new or used servo motor for my Yamaha YG100R PnP machine with original model: Q2GA04006VXS2C (Sanyo denki ) If anyone can offer it please contact me ASAP. Thanks & best regards,
Electronics Forum | Mon Jan 10 03:12:27 EST 2005 | technitelec
are you looking for a used one or a new one, may i know what is the exact Fuji number is it fcp4-2 or fcp4-3 machine??? thank you serge
Electronics Forum | Mon Aug 10 02:59:10 EDT 2020 | jmelson
I need a Sanyo Denki 103H7570-7024 stepper motor to repair a Quad QSA-30A machine. Some idiot put a 2-phase motor in there! It is supposed to be a 5-phase motor. If anybody knows where to get these, please let me know. Apparently, the same motor
Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Tue Sep 03 05:39:44 EDT 2013 | bobpan
Yes you can upload modcodes from assembler. This works for all quad c-series machines along with some others. I would NOT overwrite anything. I would save them to a new file so you have the originals. Your original modcodes are good.....your machine
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
