Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Wed Dec 23 19:50:28 EST 2020 | ttheis
Thanks; I have a spare power supply coming as well. I will start by swapping dc-dc converters first and if the problem persists swap the pdp power supply. I'll report back what I find.
Electronics Forum | Fri Jan 29 22:26:09 EST 2021 | ttheis
Thanks for the heads up. I suspect it is due to power dropping out to the IO chassis and other devices connected to the pdp. This is the first logicomm capture I have for it so I don't have other messages to compare it to. Machine has been running al
Electronics Forum | Fri Feb 26 02:41:10 EST 2021 | ttheis
We have been running the machine for about a month after replacing the pdp power supply. We have not had a repeat of the problems since. I believe we can consider this issue resolved. Failing pdp supply was a known issue in the uic kb.
Electronics Forum | Fri Jan 29 18:47:35 EST 2021 | ilavu
The error in the attached picture(FCFF1043) is for 16 I/O card located in CIO slot one for board transfer. May be thats when your PDP supply drop voltage. If problem comes back, look at that card and/or connection and/or cable.
Electronics Forum | Fri Jan 29 13:25:43 EST 2021 | ttheis
Update: I have replaced both dc-dc converters without any improvement. Observing the issue again yesterday I was able to see more of the problem. Logicomm reported a bus error at fcff1043 running "butt" (photo attached.) The DC power ligh
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Wed Dec 23 12:57:59 EST 2020 | ilavu
Check Power Distribution Panel Power Supply. No output or output too low for 24V, 15V, and 12V. Also, LED's on PDP LT6, LT7, LT8 , LT9, LT10, LT11 don't turn on at all, even though all fuses test OK for continuity.
Electronics Forum | Fri Jun 15 13:43:48 EDT 2007 | realchunks
I do want to run a profile, but they won't give > up the machine long enough for me to run one. > The boards that we are running through the wave > are large boards, with large caps, and large > transformers on it. We're building highend power
.png)
