Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Fri Mar 23 03:53:44 EDT 2007 | Guest
Hi Bert , I dont know much about IP , since I partnered our Fuji CP 6 with Siemens .At any rate, can you check your flat ribbon cable of your Ip's Head. I assume there one wire that is nearly breaking. During movement, head servo controller experie
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Thu Nov 30 22:11:25 EST 2017 | techedge
I have two KE720 P&P machines. I've been using one for the last several years on an irregular basis because we manufacture into a niche market and I don't (currently) contract out our services. Six months ago the working KE720 stopped working and I'
Electronics Forum | Mon Mar 19 23:35:10 EDT 2007 | bvdb
Hi Pete, I was using only the small and medium nozzles but it happens on both nozzles. No error message unless the delay went past about 5 seconds then a Q servo error and machine stops. Pressing reset and run enables it to continue although it th
Electronics Forum | Fri Mar 23 02:22:13 EDT 2007 | bvdb
Latest information: The IP-1 packed up completely this week showing an assortment of weird error messages. The CPU was still running but the +24VDC power supply LED was off and nothing would work (emergency stop mode always enabled). Pulling the +
Electronics Forum | Thu Sep 17 18:22:06 EDT 2020 | astarotf
Hello We have a GSM machine with two heads from the universal company, currently the machine fails to zero and in production mode, when the heads increase the displacement speed in the Y axis, they stop immediately. And the error illustrated in the i
Electronics Forum | Thu Mar 05 17:28:37 EST 2020 | sportsradar
I am desperate. I have an 80S15 with a single line controller that we program with and control our 80S15 machine. Everything has been working great until last month. We have not done any changes, and no new programs or jobs. We went to start the PC
Electronics Forum | Wed Apr 28 20:57:22 EDT 2021 | stephendo
It will be tough to get a good line for that cost. You might want to start by looking at Mydata and Juki for the machines. Ekra for the screen printer and Heller for the oven is where you might want to start. If you have not already you might want