Electronics Forum | Sat Jun 26 21:17:34 EDT 1999 | Bob Huelsenbeck
Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. Here
Electronics Forum | Sat Apr 03 17:37:27 EST 1999 | Larry Johnson
I know there is a way to zero an IP3 with out reboot the whole machine. From page zero hold down F6 and something else. This would really come in handy. If you know how, could you please let me know. Thanks in advance... Larry J
Electronics Forum | Mon Mar 15 09:14:26 EST 1999 | Todd N
Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there any
Electronics Forum | Tue Mar 16 13:49:21 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Sun Jan 24 10:49:38 EST 1999 | Ng
It has been known that sufficient cooling after soldering is important in order to get a stronger joint during its solidification stage. And it has been so much emphasised with reflow oven. But, why many models of wave soldering machine do not come w
Electronics Forum | Wed Jan 20 03:31:28 EST 1999 | Patrick O' Herlihy
| Need recommendation for Automatic site cleaning machine for BGA rework. (after component removal). | | Advice on BGA reballing equipment/methods is needed. | | thanks a lot | | Lin | You can find some info on reballing at intels site http://d
Electronics Forum | Thu Jan 07 00:05:12 EST 1999 | Chris
| Does any one have some information on Sony routing machines? Do you know the website, the contact? Thanks. | Ken, Are you looking for that small Sony router. If so, I believe you can buy it from WAND. WAND is known for punch type depaneling but
Electronics Forum | Tue Dec 22 13:56:20 EST 1998 | Michael Allen
Yes, you can adjust the board clamp speed by adjusting the flow control valve on both air cylinders (front and rear). You may also want to adjust the software delay for the conveyor so that it starts after the board is completely lowered. | Once
Electronics Forum | Fri Dec 04 00:06:48 EST 1998 | Bill Jensen
I thought Dynapert went out of business. Is anyone now using a Multitronics Dynapert machine? How is it working? What happened to the 6000. Why did they loose their agreement with this vendor? Does the 6000 work with the Dynapert? Where do I ge
Electronics Forum | Tue Nov 17 12:34:37 EST 1998 | Kurt Waskow
I am interseted in an entry level placement machine and looking for opinions and advice on manufacturers. My present line, an MPI-580 just became obsolete due to a bankruptcy situation! I need to place BGA and 20 mil fine pitch, speed is not too cr
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477