Electronics Forum | Thu Feb 19 17:03:50 EST 2004 | Grant Petty
Hi, We settled on a high end DEK Horizon printer, and thanks to everyone for the info. The machine arrives on Monday, so this will be good! Regards, Grant Blackmagic Design
Electronics Forum | Wed Dec 03 22:13:22 EST 2003 | russ
thanks for the reply Dean, unfortunately I do not have this cable to compare it with. We bought the machine used and this cable was missing. Russ
Electronics Forum | Wed Dec 03 16:51:57 EST 2003 | jay
I have a Pace Craft 25 Rework Station. If anyone knows where I can get a manual for it. Or has some manuals for a machine that they don't use or have anymore, that would be great.
Electronics Forum | Fri Dec 05 00:53:46 EST 2003 | EL
Our company is in the process of acquiring an AOI machine. Any recommendation as to what type? Does anyone have any evaluation report to share with me? MVP, OBERTECH, CRT, MVT, ETC. THANKS, EL
Electronics Forum | Tue Dec 09 01:03:59 EST 2003 | Vadim
Our company is in the process of acquiring an AOI > machine. > > Any recommendation as to what type? > Does anyone have any evaluation report to share > with me? > > MVP, OBERTECH, CRT, MVT, > ETC. > > THANKS, EL
Electronics Forum | Thu Feb 12 02:34:41 EST 2004 | Roel
We also have a benchtop by Mirtec and we are very satisfied. We also have an inline machine by Viscom. I do recommend look at a benchtop.
Electronics Forum | Fri Dec 05 12:16:35 EST 2003 | pjc
The UP3000 & UP3050 are the same machine. The "3050" denotes an options set. The current model is an UltraFlex 3000, which replaced the UltraPrint 3000 series.
Electronics Forum | Wed Dec 10 13:03:15 EST 2003 | alden
The UP3000 is the generic name for the model series. The UP3050 has the following options as standard features on the machine: Vacuum Stencil Wiper Paste Dispenser Auto Pin Placement Auto Stencil Change 2D Inspection 3D Inspection
Electronics Forum | Fri Dec 19 16:58:47 EST 2003 | rontdc
Kev, If I remember correctly, Hollis used calrod preheaters on that machine and they had a reflector under the elements to reflect the radiant waves back to the PCB. You might want to clean the reflector. If it is too far gone, use some Reynolds Wr
Electronics Forum | Tue Dec 16 19:45:47 EST 2003 | Hiram
Hi, I am looking for the IPC criteria hole-to-lead ratio. Does anybody know a practical way to determine if some holes in my pcb's do not get enough solder in the wave solder machine because an inapropiate hole-to-lead ratio? Thanks in advance! Hi
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
