Electronics Forum | Fri Dec 19 16:58:47 EST 2003 | rontdc
Kev, If I remember correctly, Hollis used calrod preheaters on that machine and they had a reflector under the elements to reflect the radiant waves back to the PCB. You might want to clean the reflector. If it is too far gone, use some Reynolds Wr
Electronics Forum | Tue Dec 16 19:45:47 EST 2003 | Hiram
Hi, I am looking for the IPC criteria hole-to-lead ratio. Does anybody know a practical way to determine if some holes in my pcb's do not get enough solder in the wave solder machine because an inapropiate hole-to-lead ratio? Thanks in advance! Hi
Electronics Forum | Wed Dec 17 08:23:56 EST 2003 | paul_bmc
Can anyone tell me the pro's and con's of Contact Systems CS-400 E semi auto Cut and Clinch machines. (1998 vintage)
Electronics Forum | Wed Dec 17 10:06:33 EST 2003 | Barney
Not a bad machine, However be carful. Contact is not doing well and support and spare parts may be a big issue in the near future
Electronics Forum | Wed Dec 17 10:43:12 EST 2003 | paul_bmc
Do you have any other suggestions for Semi Auto Cut and Clinch machines. Because of Contact Systems reputation I was leaning towards them, but I had no idea they we having problems.
Electronics Forum | Mon Dec 29 13:27:52 EST 2003 | cyber_wolf
Does anyone know whether or not it is possible to convert a right to left kanetic telescoping shuttle to a left to right machine ? Thanks
Electronics Forum | Mon Jan 12 15:03:43 EST 2004 | davef
We read what you wrote, but were unclear on what you were asking. Like: What's a feeder maintenance footprint? We don't consider feeders to be tools. Each is a calibratable machine with seperate maintenance and calibration schedules.
Electronics Forum | Fri Jan 02 11:30:54 EST 2004 | JG
We purchased this wave solder machine used. It came without the operating software (TECDEV). I want to know how to adjust the temperature deviation setpoint. Does anyone know how to do this? Thanks in advance, JG
Electronics Forum | Mon Jan 05 15:14:26 EST 2004 | Debbie A.
Hi JG, You can contact the factory at 310-618-8427 and asked to speak with the service department. We support all of our machines regardless of ownership.
Electronics Forum | Fri Jan 09 11:15:00 EST 2004 | jmr2
We have a X- ray machine, CXR2000 from CR technology and Am having difficulties in locating a this company. for service and spare parts If anyone has any ideas, it would be greatly appreciated
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477