16469 machines results

Electronics Forum: machines (Page 661 of 1647)

depanelisation of IMS board

Electronics Forum | Wed Mar 31 01:25:16 EST 2004 | amil

dear all, we prepare ourself to assembly IMS board The PCB design with V cut How to depanelisy it? With scoring machine or manual breaking? Any experience Thanks G�bor

Join venture in PCBA

Electronics Forum | Wed Mar 31 20:53:20 EST 2004 | marcowong

If you are an existing PCBA house and looking for ways to reduce your overheads and maintain cost competitiveness. We are able to help and team up to do something. We are able to provide man power, factory facilities and space except machines and act

Fiducial recognition using laser

Electronics Forum | Thu Apr 01 14:11:38 EST 2004 | cedams

Many years ago I remember the Philips CSM series SMT machines used a small tubular laser system for identifying fiducials on the PCB. Can anyone suggest suppliers for these devices. Thanks.

TDK Axial/Radial Programming software

Electronics Forum | Fri Apr 09 11:48:29 EDT 2004 | jbservices

TDK can supply the cables and software, you supply the PC, all they need is machine serial number to suply you with correct version of software. let me know if you are intersted and you can contact them direct. thanks john

Camalot 1818 software request

Electronics Forum | Mon Apr 12 09:28:48 EDT 2004 | pasprobe

I need the software to run the camalot 1818, I can't get any support from camalot because the machine is to old. So I really need this software. My serial number is 108.

Water Soluble for No Clean BGA Balls

Electronics Forum | Tue Apr 13 19:59:21 EDT 2004 | davef

Most 1.27 pitch BGA can be cleaned with modern machines. As far as the timing of cleaning OA flux res, obviously the sooner the better. After that different fluxes are different. This must be a common question for cleaning professionals. They pro

contamination on copper

Electronics Forum | Thu Apr 15 08:23:47 EDT 2004 | prod

hi, Having put a copper socket trough a wave soldering machine, and then through a DI wash, the boards have been dried and after a few days a green residue has been noticed on the copper. any suggestions? not drying properly maybe? or could it be th

Minimum Efficient Production Volumes

Electronics Forum | Tue Apr 20 10:27:35 EDT 2004 | russ

How about how much did it cost to set-up and run vs. how much $$ you made. You should already have some established margins for your machine time? Russ