Electronics Forum | Thu May 06 16:34:02 EDT 2004 | vickt
System Clear is not always on option, and I'm not sure in this specific case if it will "let you". If it will, it should have the same effect. You may want to review the "warm start" function of the machine as well. This is an "auto recovery mode" th
Electronics Forum | Wed May 05 01:44:56 EDT 2004 | fastek
Sam- MPM USA won't help you on this unless you have registered the machine with them. Contact the China support guys and they will probably help you out.
Electronics Forum | Fri May 07 17:39:15 EDT 2004 | dedwards
Sam call Harry Parriott at Value Machine Sales in Ohio, USA. He is a MPM expert that used to work for MPM. He buys, rebuilds and sells MPM stencil printers. 740-344-4260
Electronics Forum | Fri May 14 17:09:43 EDT 2004 | russ
pete, you forgot the board flipper and the same line duplicated again for two sided boards! and how about an Xray machine after each oven in case the flying probe cannot test all lines?
Electronics Forum | Fri May 07 02:27:57 EDT 2004 | Grant Petty
Hi, They do what we need component wise, however I was wondering if anyone had info on reliability, ease of programming. We are looking XP 142 and 242 series chip shooters and fine pitch placers. Regards, Grant Blackmagic Design
Electronics Forum | Mon May 10 17:21:03 EDT 2004 | smt..
I work with Fuji equipment For over 10yrs�. Cp3, cp4.cp6.cp7, ip1, ip2, ip3, qp341, qp242, qp351. Also, work with MYDATA, SAMSUN, and QUAD AMISTAR�. Fuji is the best in my opinion.
Electronics Forum | Mon May 10 17:21:08 EDT 2004 | smt..
I work with Fuji equipment For over 10yrs�. Cp3, cp4.cp6.cp7, ip1, ip2, ip3, qp341, qp242, qp351. Also, work with MYDATA, SAMSUN, and QUAD AMISTAR�. Fuji is the best in my opinion.
Electronics Forum | Fri Jun 04 10:19:30 EDT 2004 | gregf912
Your autmated system fired back to me that you have been bombarded with mail on this subject. I am sure you have. You can get my address by going to my website at WWW.ATS-SMT.COM from there we can discuss the issue in more detail.
Electronics Forum | Mon Jun 07 04:42:30 EDT 2004 | Grant
Hi, It's worth taking a look, and we are still yet to make a decision. Have not really heard of these outside the forums here, and unsure of local support too. Where can I get some more info? Regards, Grant
Electronics Forum | Sun Jun 13 07:48:18 EDT 2004 | Grant
Hi, Thanks for the info, and can you provide a little more info on some of the reasons you think the Fuji is better than Universal. For example, can you explain some of the advantages and disadvantages etc? That would be really helpful! Regards,
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
.gif)
