Electronics Forum | Mon Jan 19 15:33:49 EST 2004 | J Smithj
We were and still are having problems with magnetized nozzles on the HSP 4796. The problem was found when numerous parts were thrown after being placed on pad. It appeared to be picking parts up off the board after placement. Nozzles were pulled out
Electronics Forum | Wed Aug 03 10:01:39 EDT 2005 | GS
Hi Crishan, sorry, "pbm" is a short way to say problem. In the past ('89), we had same magnetic pbm also with metal nozlles on Dynaper MPS-2500. Some time, we found also chips received from supllier already magnetized. Solution was to put the r
Electronics Forum | Thu Oct 20 12:50:11 EDT 2005 | bobl
I used to collect mine in a 50 gal drum and take them to the scrap dealer. If he classifies it as brass or copper you can get a good return. Most leads are nickel and tin plated brass. Most dealers stick a magnet on it and tell you its not worth much
Electronics Forum | Mon Feb 22 10:01:01 EST 2010 | jtsyeung
Since the inductor is electro-magnetic, that means the device is composite of coil and ferrite metal. The inductor inside the reflow oven meets with blower motors which close to the inductor and generate magnetic field. With such conditions, Lawren
Electronics Forum | Thu Jul 15 19:22:26 EDT 1999 | Jeff Sanchez
I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys.
Electronics Forum | Tue Jan 20 08:42:09 EST 2004 | Primus
We have four 4796 machines, and I have not yet seen this problem. By chance did You check to see if the Nozzle Storage Plate is magnetized? Just a thought. Hope this helps.
Electronics Forum | Fri Jan 23 13:17:59 EST 2004 | Gabriele
Make sure chips (some Resistor contain nickel,or A-42 (Fe-Ni)leads made like SOT-23, etc )some time they also are magnetized and get attracted by nozlles tips. rgds
Electronics Forum | Tue Jan 27 07:56:15 EST 2004 | siverts
Don't forget the monitor's. There are only two ways to get out of this problem, if the monitor get's magnetizised: 1. Replace the monitor. 2. Turn in the monitor to a Tv-repairman that can do a de-magnetizing of the monitor.
Electronics Forum | Wed Feb 02 08:39:33 EST 2005 | David N Nadel
Looking for non magnetic 1% surface mount resistors. Does anyone have a clue where to find them?
Electronics Forum | Fri Mar 11 10:00:22 EST 2005 | ???
Anybody out there know of a good (2nd) source to purchase single magnetic board supports used on quad/samsung machines. These are spring loaded and contact the underside of the board in the pick n place machine
