Electronics Forum | Tue Feb 13 13:49:57 EST 2007 | coop
I am talking about an internal tray holder It holds two trays. the lingo doesn't really matter because if you say Internal tray feeder/holder the guys at philips will know exactly what you're talking about. I checked several refurb places and the onl
Electronics Forum | Fri Dec 17 09:05:55 EST 2004 | adlsmt
Has anyone designed a Topaz matrix tray holder? We only need something to hold 4 trays and the Assembleon system is expensive and marginal. We can do it here but if someone else has done it would be happy to share the engineering costs to get some dr
Electronics Forum | Mon May 14 15:20:35 EDT 2001 | stefwitt
You can make up a plate over lapping the tape exit guide and to the right up to the nozzle changer. It should hold three standard size Jedec trays. I used the bases of two old vibratory feeder. No matter what you do, you should use strong magnets to
Electronics Forum | Sun Jan 25 15:07:14 EST 2004 | davef
No one handling floppy disk should have a magnet on his or her wrist or in their work area. Furthermore, those with a magnetic paperclip holder on their desk should not allow floppy disks to come in close proximity to it. Since only technicians handl
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Tue Jun 24 14:00:58 EDT 2014 | joekirin
We built a tray that accepts tape. It is made out of a waffle tray and board breakaways. It works very well. We use magnets to mount it on our Y-Wagon teaching it as a tray.
Electronics Forum | Thu Oct 29 10:29:13 EDT 2009 | soporto77
Hi, I'd like to know where i can find a Matrix Tray holder cheap (Pick and Place Samsung CP45 Neo) Thank you for your help
Electronics Forum | Mon Jan 26 21:28:55 EST 2004 | Dean
If this is in regards to the manufacturing floor: I can remember years ago I had an Fuji IP3 + MTU4. Used square magnets to hold tray stacks square to the machine. Manufacturing manager told me they should not be used. Apparantly the magnetic fie
Electronics Forum | Tue Jun 24 11:58:55 EDT 2014 | markhoch
We had both a MY15 and a TP11 both with tray wagons and we taped strips to the tray wagon all the time with great success. we used double sided tape, sometimes with magnets, and then created "trays" as if the tape strip was a matrix tray. (1 x 10,15
Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax
"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest
