Electronics Forum | Thu Mar 28 02:24:55 EST 2002 | ianchan
Right....thanks for your opinion.
Electronics Forum | Mon Jan 26 09:42:20 EST 2004 | kauer
Any luck with the Nozzles?
Electronics Forum | Wed Feb 02 09:59:10 EST 2005 | David
tring to find non magenetic surface mount header pins
Electronics Forum | Thu Mar 16 11:33:52 EST 2006 | cyber_wolf
When I flip the switch to lock the stencil, the magnet in the carriage cylinder pops free..... Any ideas ?
Electronics Forum | Tue Feb 05 15:55:54 EST 2013 | rway
http://www.cotorelay.com/images/stories/coto_wp__reliability_ver_003.pdf I believe this was provided mainly for informational purposes; however, you don't need all that. You just need a magnetic field. A simpler approach than what I have already m
Electronics Forum | Wed Jun 12 14:05:40 EDT 2019 | proceng1
Good deal. I've had this issue many times and the magnetic switches almost always fixed it.
Electronics Forum | Fri Jan 14 03:52:34 EST 2000 | Scott Davies
To any users of Camalot Adhesive Dispensers... Do any of you know where I could get hold of the spring loaded magnetic board supports used on, for example, the 3800 machine. Camalot's representatives here in the UK, Speedline, are asking a ridiculou
Electronics Forum | Thu Jul 15 22:40:43 EDT 1999 | Dave F
| I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | Jeff: Scott's correct. Buy a mechical stripper f
Electronics Forum | Thu Feb 16 21:22:12 EST 2006 | davef
It is quite common for this to be done with an activator cured acrylic adhesive (eg, Dymax, Loctite, Permabond). This method took over from mechanical clips and epoxy some years ago because using: * Mechanical clips changes the magnetic circuit. * Ep
Electronics Forum | Tue Dec 05 09:09:38 EST 2006 | sigmasmt
These feeders come from an old OEM plant. They had a in house system they put together so the machine will not run until you had the correct feeder in place. Once the feeder was scanned and put into the feeder slot, the magnet would help recognize t
