Electronics Forum | Tue Jun 24 14:00:58 EDT 2014 | joekirin
We built a tray that accepts tape. It is made out of a waffle tray and board breakaways. It works very well. We use magnets to mount it on our Y-Wagon teaching it as a tray.
Electronics Forum | Mon Jun 23 15:28:41 EDT 2014 | globalpowerproducts
I have a 1997 DEK 248 screen printer that does not have the magnetic suction cups. Any thought on where i can find these or suggestions on how to secure the board on the table?
Electronics Forum | Thu Aug 07 14:37:00 EDT 2014 | eugene_em
Why use magnets? I found a KS project of a pcb prototyping machine that uses vacuum for PnP. Here is a video https://www.kickstarter.com/projects/botfactory/squink-the-personal-electronic-circuit-factory/posts/929661
Electronics Forum | Tue Jan 13 07:27:32 EST 2015 | donb_68
Are you using any flexible magnetic tooling with it or are you using dedicated fixtures for holding your array's?
Electronics Forum | Mon May 20 06:40:39 EDT 2019 | paulanderson
Thanks - This is exactly what it was. Separately I was isolating each of the safety circuits on the main board and that confirmed it was the top lid magnetic switch was faulty. It was the only one not shown as an input in the diagnostic page :(
Electronics Forum | Fri May 24 13:04:10 EDT 2019 | tey422
Have you tried to test the X-axis stepping? I am suspecting might have to do with the Encoder with X-Magnetic strip.
Electronics Forum | Fri Sep 18 18:20:45 EDT 2020 | dwl
Count on Tools makes hard foam support block with magnetic bases that work really well. check with them to see if they make them for the SPV. Insert standard: I receive no benefit nor compensation from the aforementioned company.
Electronics Forum | Fri Sep 03 17:39:06 EDT 2021 | stephendo
The most common issue with baking parts for removing moisture too much, is oxidation of the leads. But I haven't seen that too much. I'm really curious what moisture magnets are and how they work.
Electronics Forum | Wed Aug 23 17:22:39 EDT 2023 | markhoch
I'm curious what you use for PCB Support. Are you using a dedicated support plate or are you using magnetic pins or some type of Grid-Lock system?
Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
