Electronics Forum | Thu Aug 07 17:25:11 EDT 2008 | jlawson
With Laser centering nozzle condition in terms of slider shafts have to return to same position every time. Please check condition of nozzle and make sure slider extends to full position. If slider sticks it can generate errors as the component appea
Electronics Forum | Thu Nov 03 16:57:16 EDT 2022 | spacecase
I did clean the nozzles, but some of them are older so I will check and swap out with better looking ones. Thank you for the response, troubleshooting seems to be the main part with these things
Electronics Forum | Tue Dec 16 11:41:26 EST 2008 | fredc
I think fuji and all the after market suppliers use stainless "hypo" tubing for the tips. It is made from 304 stainless which is normally nonmagnetic. In the process of forming this tubing to the hypo specs it is work hardened to 3/4 to full hardness
Electronics Forum | Tue May 20 14:50:06 EDT 2008 | mmjm_1099
I have dealt with SMT Research myself as well for many years. I would rather pay for quality of a product than just something that seems cheaper. Be on the look out for steel nozzles as they will become magnetized and cuase you many problems. So if y
Electronics Forum | Tue Jun 10 23:06:28 EDT 2014 | demzvill
In our assumption also, nozzle is magnetized because the chip termination is made up of alloy so possibilty that when there is excessive contact between two metals there magnetic field produce, so during z up chip is magnetize on the nozzle causing i
Electronics Forum | Mon Jan 19 15:33:49 EST 2004 | J Smithj
We were and still are having problems with magnetized nozzles on the HSP 4796. The problem was found when numerous parts were thrown after being placed on pad. It appeared to be picking parts up off the board after placement. Nozzles were pulled out
Electronics Forum | Mon Jan 26 21:28:55 EST 2004 | Dean
If this is in regards to the manufacturing floor: I can remember years ago I had an Fuji IP3 + MTU4. Used square magnets to hold tray stacks square to the machine. Manufacturing manager told me they should not be used. Apparantly the magnetic fie
Electronics Forum | Wed Jun 11 08:53:53 EDT 2014 | fredcalkins
That would be easy to check. Degaus the whole nozzle not just the tip. It should take more than a week to become magnetized again. If it becomes magnetic sooner maybe degauss the head? I would also make sure your vacuum does not come on till the noz
Electronics Forum | Tue Jan 20 08:42:09 EST 2004 | Primus
We have four 4796 machines, and I have not yet seen this problem. By chance did You check to see if the Nozzle Storage Plate is magnetized? Just a thought. Hope this helps.
Electronics Forum | Mon Jan 26 09:42:20 EST 2004 | kauer
Any luck with the Nozzles?
.gif)
