Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Thu Mar 19 21:06:19 EDT 2020 | sarason
In circumstances like these immediately switch off and remove your power supply , I often build a test harness because the damage to an expensive and unique machine is not woth the trouble of shotgun repair. Dead resistors in the voltage sense rail.
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Tue Oct 17 08:05:22 EDT 2023 | unsung
I don't see your email in my inbox sir. It's a lot to write. Check all your power supplies make sure all of them light up in your machine and Check the Main Start Switch if it correctly works the ignition green button switch you should here a thumb n
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Mon Jan 25 15:51:02 EST 2016 | aemery
SP1 is a bi-metal spring loaded switch or the "air fault" switch on the main air manifold that detects the presence of an appreciate amount of air being supplied to the machine. Air pressure overcomes the adjustable spring and closes the contacts.
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
Electronics Forum | Fri Apr 14 03:27:07 EDT 2006 | bvdb
The latest news. We ran another production run for 1-1/2 hours. The IP-1 gave a "memory NG" fault indicator twice after fully completing the first and second PCB's. We've been running the tray speed at 30% but noticed that the speed of the tray ro
Electronics Forum | Thu Mar 18 09:25:27 EST 2004 | remullis
Normally when I run into having to hit the ESC key to step through this is the steps I take. 1. Power machine down and restart. 2. Home machine and watch cutter carefully. Both cutter should acuate and the height motors should run CW and CCW. 3. You
