Electronics Forum | Sat Jul 05 14:07:33 EDT 2008 | shellydhami
Main diffrences in failure modes for mechanically and thermally induced BGA solder joint fracture
Electronics Forum | Fri Oct 27 08:18:23 EDT 2023 | avaqsemi
what are the main differences tmc5160 vs tmc2209?
Electronics Forum | Mon Dec 05 17:46:10 EST 2022 | SMTA-64387381
Does anyone have experience with routing through areas of PCBs with Cu traces running through them. Trying concept to design in functional "wing" portions to our main board in an effort to get 2 in 1 functional boards - a fully functional main PCB
Electronics Forum | Tue Feb 29 21:18:00 EST 2000 | Gwen Z
When an assemblied board was on active service, what's the main reason for its failure:the package broken; the mechanics fatigue failure under thermal cycle; the corrosion caused by salt and vapor; the broken chip inside the package etc. I think all
Electronics Forum | Tue Feb 29 21:18:00 EST 2000 | Gwen Z
When an assemblied board was on active service, what's the main reason for its failure:the package broken; the mechanics fatigue failure under thermal cycle; the corrosion caused by salt and vapor; the broken chip inside the package etc. I think all
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Tue Feb 25 03:32:58 EST 2020 | bukas
hello guys, I got a problem with MAIN START switch on Samsung CP45FV NEO. The switch itself works, and it activates contactors #1-1 #1-2 and #3 but after pressing READY button there is en error msg reporting that MAIN START has not been pressed. Alre
Electronics Forum | Wed Dec 08 18:22:47 EST 2004 | msjohnston1
Here is a list of companies that have solder paste inspection equipment that use a laser for measurements www.gsilumonics.com www.orbotech.com/products_assembly_main.asp www.fa.panasonic.co.jp/products/smt/inspection/main/ipm_e.html
Electronics Forum | Fri Aug 08 11:39:33 EDT 2008 | ethancw1sel
Thanks for your input. I too thought the pogo pins would be the main issue. But we've been running with ours for about 6 months, and we've not replaced one pogo pin block. But we've replaced 4 or 5 various sensors. The PSV and Tension sensors are
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
