Electronics Forum | Wed Jul 15 12:44:11 EDT 2009 | thanhnguyen
The Tant size is 3528-21. I use type 72 nozzle > for it. check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
Electronics Forum | Fri Jul 17 12:07:14 EDT 2009 | azhiker
See attachment. Hope it is useful. DucHoang, Thanks for the info. This is exactly what I was loking for, since I didn't have a DEK manual with me. Thanks a lot!
Electronics Forum | Tue Jul 21 06:23:07 EDT 2009 | Jeff
Instead of using a conversion box just make your own cable. Look in the Dek manual, volume #2, chapter 18. It shows you how it's wired. Easy to make and looks allot cleaner than those conversion boxes.
Electronics Forum | Tue Jul 28 09:29:48 EDT 2009 | christian01976
Hello! Did you test the blow off function manually with the input/output monitor? Mayba there is the wrong plug at the valve...
Electronics Forum | Fri Jul 31 17:03:21 EDT 2009 | isd_jwendell
My Essemtec machine can use "restband" feeders. They are manual feeders that simulate trays, but are specifically made to hold tapes.
Electronics Forum | Tue Aug 25 01:33:00 EDT 2009 | hurr
Hi Jack, we have in our comapany My15 and MY9. Both machines we programming almost daily only in excell. First manually, second with excell macro. Both alternative are almost camparable. It´s depending on amount of SMD parts and skills. Radek
Electronics Forum | Tue Sep 01 12:20:47 EDT 2009 | fujiphil
Manually load the board and activate the solenoid for table up/down. Goto I/O then check the status of the sensor. if the sensor was tripped when table is down, removed the pin and check for foreign objects. Or check the hole of the pcb, maybe the si
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Wed Oct 21 12:18:16 EDT 2009 | clampron
Eric, Here is the link for Testronics support. They should be able to get you a manual. info@testronics.com Chris
Electronics Forum | Sat Oct 17 18:43:56 EDT 2009 | emanuel
Just a moment.... when the machine was installed I was told to use a dry air line, so it is connected to a line that passes through an air dryer and no oiling at all. Should it have oiler installed? I will check the installation manuals