Electronics Forum | Mon Aug 29 18:25:57 EDT 2011 | sevenzero
What options are available for reading in XY data and combining it with a BOM? Also, we need to generate XY locations manually from gerber data. I would prefer something with a hard lock dongle.
Electronics Forum | Wed Aug 31 11:51:38 EDT 2011 | peteb
We bought a Vitronics reflow oven used. No fee to register. Support from Vitronics was very helpful and friendly. Machine is well made and works great. All manuals are on the computer that runs the oven.
Electronics Forum | Wed Sep 14 04:39:43 EDT 2011 | dilogic
It has very simple construction - there are two rubber o-rings which serve as a coupling. On ours, one was broken and after replacing it with a new one everything was as new. Just open the head and it will all be clear - it's very easy to fix. - Den
Electronics Forum | Mon Oct 31 21:08:19 EDT 2011 | davef
Second, make sure your fiducial data for pick and place programs are built from CAD data and NOT manually at the machine.
Electronics Forum | Wed Nov 02 00:48:05 EDT 2011 | tpappano
Thanks for the reply, all the parameters are being entered, but there is something subtle causing the error messages, likely some silly thing I'm overlooking. Hopefully someone is familiar with these error messages, because the manual hasn't been mu
Electronics Forum | Fri Nov 04 05:05:18 EDT 2011 | tzucury
I have a vision problem because the cam is seeing blurry, but if i manually lift the board it's starting to see more clearly, how could i fix this focus problem?
Electronics Forum | Fri Nov 04 13:08:32 EDT 2011 | dwoodbury
Hi. We are having problems with what appears to be the firmware for our QP341 machine. It will not allow us to calibrate or change any settings for the pick-up-point on the tray unit. We are following the procedure in the manuals but it is not workin
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Tue Feb 21 10:58:02 EST 2012 | ppcbs
Can anyone suggest a good underfill compound that is readily available for manual dispensing. I need to underfill a small BGA less that 12mm square.
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
