Electronics Forum | Mon Oct 31 21:08:19 EDT 2011 | davef
Second, make sure your fiducial data for pick and place programs are built from CAD data and NOT manually at the machine.
Electronics Forum | Wed Nov 02 00:48:05 EDT 2011 | tpappano
Thanks for the reply, all the parameters are being entered, but there is something subtle causing the error messages, likely some silly thing I'm overlooking. Hopefully someone is familiar with these error messages, because the manual hasn't been mu
Electronics Forum | Fri Nov 04 05:05:18 EDT 2011 | tzucury
I have a vision problem because the cam is seeing blurry, but if i manually lift the board it's starting to see more clearly, how could i fix this focus problem?
Electronics Forum | Fri Nov 04 13:08:32 EDT 2011 | dwoodbury
Hi. We are having problems with what appears to be the firmware for our QP341 machine. It will not allow us to calibrate or change any settings for the pick-up-point on the tray unit. We are following the procedure in the manuals but it is not workin
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Tue Feb 21 10:58:02 EST 2012 | ppcbs
Can anyone suggest a good underfill compound that is readily available for manual dispensing. I need to underfill a small BGA less that 12mm square.
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
Electronics Forum | Tue Apr 03 12:48:50 EDT 2012 | emeto
Hi, I like DEK better. Each of them will have some advantages over the other one, but DEK Horizon software you can learn in a day without opening the manual. It is so easy to work with it.
Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Sat May 12 02:19:31 EDT 2012 | bwjm
Hi thanks for your advice. Between, i do have quite a bit of THT PCBAs. How do you guys improve the productivity of manual inserting?