Electronics Forum | Wed Mar 12 12:33:50 EDT 2014 | alphatronique
Thank Brad Fab 3000 was first soft i try that actually work without need to read whole manual and it price was right ..
Electronics Forum | Thu Nov 20 06:11:16 EST 2014 | leeg
Thanks Gary, I have found that you could fix them in program editor and then use the manual assign option, the only problem then is that you cannot output a text file for the common program, the option is greyed out.
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
Electronics Forum | Wed Mar 19 18:40:03 EDT 2014 | guts1872
We use IQ feeders from PPM and cant find any reference material on maintenance and calibration of these feeders. Does anyone here know where I can get repair manuals, diagrams, or any info on these feeders at all?
Electronics Forum | Fri Apr 25 08:33:57 EDT 2014 | preeticeda
how?? we have to do this manually? if we have a big board with so many components it would be very time consuming.
Electronics Forum | Mon May 26 04:59:12 EDT 2014 | jandon
Have you try to change feeder place manually somewhere else? Maybe even rear side of the machine?
Electronics Forum | Mon Jun 16 23:15:41 EDT 2014 | sarason
Try asking the question in the Zevatech Yahoo group. https://ca.groups.yahoo.com/neo/groups/zevatech/files sarason
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Wed Jul 30 13:02:56 EDT 2014 | proy
Through hole headers in long strips Anybody know of a tool/manual punch and separate these instead of sidecutters very slow....
