Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon Aug 03 07:14:38 EDT 2020 | bangir
Hi, How to adjust the table height of Screen Printing EKRA X5? Could you share me the Manual System Operation?
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Thu Aug 06 05:29:25 EDT 2020 | bangir
Hi Chris, Thank you for your advise. We got problem on key in parameters. Why we can't save value on parameter after key in manually? When we key in Parameter, we used password 9060. Is there any other password to key in and save machine parameter? T
Electronics Forum | Mon Jan 23 22:53:31 EST 2012 | davef
= 0.66 aperture opening to the stencil wall has been shown to provide the best transfer efficiency and repeatability of the deposited paste. Values from 0.66 to 0.8 insure a good paste release from the stencil. The biggest impact on area ratio is the
Electronics Forum | Tue Jul 07 09:43:07 EDT 2015 | protokos
Hi all. I can buy 2 Royonic 510 tables. Now im looking for a manual , how to programm them. can anyone help me with a copy of the manual or, give me an workinstruction how to programm them Tanks Wil.
Electronics Forum | Mon Jul 20 11:31:52 EDT 2015 | heatherc
Aegis software has a programming solution for offline programming of these machines. http://www.aiscorp.com
Electronics Forum | Wed Aug 18 21:10:23 EDT 1999 | se
| | | Hi, | | | I'd like to ask some tips about the merits and shortcomings o | | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | | application? | | | The board
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Thu Apr 29 14:41:12 EDT 2004 | pjc
OK if the paper is transparent and you can adjust the table X-Y-Theta under the paper- without moving the paper - the align with the solder lands on the board. If you have a DEK or MPM machine, the Mylar frame is like $300. I belive other printer mfr
.gif)
winsouce.jpg)