Electronics Forum | Mon May 07 22:28:17 EDT 2007 | colormaker
radiant heat. 137c The hollis was a great machine. The one I had the prehead wass on or off there was no setting. The pot temperature guage was brocken so I had to guess and manually turn the heater on and off. The whole machine was covered with 1 i
Electronics Forum | Mon May 21 18:24:42 EDT 2007 | kz9yyc
Hello, I am looking for any information regarding Assembleon's FCM Base II coordinate system. While some of my problems are due to inexperience and ignorance, I have read every manual, technical bulletin, and online message available to me, and I s
Electronics Forum | Wed May 30 13:50:57 EDT 2007 | rgduval
I replaced an upper element in an 1800W. Took about 4 hours total. That included arguing with the rusted in screws, messing around with warped shields, and a call to Heller Tech Support to go over how to do it. In the end, it wasn't nearly as comp
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Mon Jun 11 10:13:26 EDT 2007 | hussman
I would also "nice to have" because of your process. Inspecting solder paste from a 2D point of view manually would not assure you quality if the paste is 75% off pad. Plus hand placing onto solder paste causes it's own set of problems which will c
Electronics Forum | Thu Jun 28 11:51:24 EDT 2007 | mika
Hi, Are we talking about the pick-up tolerance so for any chip component set it to 0.5mm. It will save a lot of trouble right there. As for body tolerence if it is a zero then it will automatically use a standard value, based on the size of the body
Electronics Forum | Thu Jul 12 07:38:23 EDT 2007 | avalancher
Hey Sr, I agree that 130 is enough to pull a tiny little 0402, but I think that your forgetting response time. The machine has a small reservoir built in the system that keeps some moderate standing vacuum, however, when a part is picked, there
Electronics Forum | Mon Aug 06 11:58:48 EDT 2007 | gmoritz
Do you have BEC (Board Error Correction) > on that machine, and if so, did they > give you the alignment plate for it? I don't know if we have BEC on the machine. I can't even search the 550 page manual that was finally sent to us in a pdf file
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
Electronics Forum | Fri Aug 17 11:53:42 EDT 2007 | escalador
Hi Dejan: Glad to hear from you. I will check the soft version as soon as I get a transformer. I tried to register on the Universal page without success.I suspect that I have to buy something...,someone from Universal in Spain contacted me by phone