Electronics Forum | Fri Oct 03 23:57:23 EDT 2003 | Dean
Buddy system at a minimum. In fact it does no good to verify your "stock" number. You need to verify the manufacturers numbers as-well. And even then, reels do get mis-labeled. I seem to remember a story of a major CM supplier for a Big 3 car mak
Electronics Forum | Thu Oct 02 18:53:36 EDT 2003 | Michael Nguyen
We are using a Trek board washing system with 2 deionizer tanks hooked up to the 2 final rinse tanks and the first tank is directly connected with the city water. We are having problems with a vendor board on some tranformer/chokes. The part manufact
Electronics Forum | Tue Oct 14 23:59:49 EDT 2003 | MA/NY DDave
Hi I am going to take another direction. Go to some classes, and buy some of the books, or hire a consultant to get you up fast. A consultant would be my first choice for speed and accuracy. National Training Center for Microelectronics in Bethleh
Electronics Forum | Wed Oct 15 12:03:11 EDT 2003 | blnorman
What works in Alaska will probably not work as well in Florida. We have solder paste vendors give us direction with their specific paste, but we also impart our required process parameters on their paste. For instance, here in Alabama in the summ
Electronics Forum | Fri Oct 24 18:07:50 EDT 2003 | russ
Flux is used with both lead and lead free. Lead free usually or always uses a no-clean chemistry while lead uses both no-clean and water soluble dependent upon the application. As far as temp profiling a standard way to go is melting point + 30 C. f
Electronics Forum | Tue Nov 11 13:00:14 EST 2003 | Kevin McCarten
John; Our company supplies Dry Boxes specifically deisgned for the electronics manufacturing environment. We have a variety of products that are capable of handling the various loads that you may request of them (ie; frequently acessed production fl
Electronics Forum | Wed Nov 19 10:11:10 EST 2003 | loz
We have just got involved in conformal coating, with mixed results. We are machine spraying and have experienced various machine issues. Another one was the consistency of the material being sprayed, we mixed it ourselves (badly?). We now buy it pre-
Electronics Forum | Mon Dec 01 12:33:20 EST 2003 | frank
I see where I went wrong. The numbers provided by "Process Engineer" are correct. My company is trying to adhere to the Six Sigma code of business and the managament here falsely assumed that all of our equipment can do that as well. After doubl
Electronics Forum | Tue Dec 02 08:40:27 EST 2003 | Daniel Werkhoven
Dear Tom, As manufacturer of solder chemicals for the electronic industry we know we can help you out with your problem. To go no clean you most only organise that the chemistry that stays behind on yr PCB will not cause any problem during the life o
Electronics Forum | Tue Dec 16 23:57:58 EST 2003 | Grant Petty
Hi, Thanks for the feedback, and this has been helpful. Still not sure what we are going to get yet though. We are based in Australia, so it's also dependent on local support. This can be a problem, because when everything is going ok, all the sal