Electronics Forum | Wed Feb 14 14:16:25 EST 2007 | branman5
We are a pcb manufacturing facility and we have a question. We wash our boards in a metal wire rack that has latex � inch tubing connected to it so the pcbs do not move from water or air flow. It acts as a buffer between the wire cage and the pcb. Ca
Electronics Forum | Wed Feb 21 16:20:11 EST 2007 | jmelson
I would appreciate any pointers to smaller machines that are newer and more flexible (vision, mostly). I am a one-man manufacturer, and have been doing all boards by hand so far. So, my budget on this is pretty small, but I understand that getting
Electronics Forum | Thu Feb 22 09:21:57 EST 2007 | Cmiller
Mydata would be good, Contact Systems would be good for what you are doing, very good software, crappy feeders but fine for 0805 parts. You may be able to get a Universal GSM pretty cheap these days. If you make a decision then look for a machine you
Electronics Forum | Wed Feb 28 10:27:55 EST 2007 | Rob
Hi John My understanding of your post is that you are asking if anyone has tried to enforce MSL levels or reflow parameters onto the component vendor/manufacturer. Is this your question or am I mis-interpriting it? If that is the case you will not
Electronics Forum | Sun Mar 04 20:06:46 EST 2007 | alphamoose
Hey Guys, We are looking to set up a line to manufacture low volume high mix PCBs. We have work in the display technology and military sectors. Part tracking, lot tracking are critical. The machine may also end up in a class 10,000 or 1000 clean room
Electronics Forum | Mon Mar 05 15:56:21 EST 2007 | jasont
NM-2858 is European style M size MV2F. NM-2859 is European style XL size MV2F. MV2F is manufactured rated at 0.1sec per placement however, I have only seen them acheive around 20-25,000 cph I have x2 MV2F-XL "Q" in stock (NM-2559MB) w/feeders. IF
Electronics Forum | Fri Mar 16 06:36:35 EDT 2007 | realchunks
Hi Chris, You should check your data sheet from the paste manufacturer, but the bottom line is, does this wait step cause any quality problems? If not, then it's a hard argument to say this is a bad practice. Next you may want to find out why th
Electronics Forum | Tue Apr 10 14:01:24 EDT 2007 | paul_stamper
Mark: One thing you will find with the Panasonic software is that it will use one component file for the same size/shape component. This is a good starting point. However, you may have better succes changing the part numbers you tend to lose more of.
Electronics Forum | Wed Mar 21 23:02:04 EDT 2007 | Guest
I did convert YM 84V for 0402, base on my expperience , this approach is not really good.This model were not really meant for 0402 placement. Nozzle H ID is really small and prone to clogging, therefore cleaning every 2 hours is a necessity( not id
Electronics Forum | Sun Mar 25 15:38:07 EDT 2007 | Gibbon!
Couple of things. Type T thermocouples are solder friendly. However usually a header with screw terminals poses no problem as the temperature differential is nil. Getting thermocouple leads wet causes problems because two dissimilar metals + condu
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
