Electronics Forum | Wed Jun 11 07:44:04 EDT 2008 | davef
To get started, look here: http://en.wikipedia.org/wiki/CE_mark
Electronics Forum | Wed Jun 11 04:10:26 EDT 2008 | bahabaha
Hi,, I need to put CE maek on my pcb , but I was told to follow the standard , what is the font type we need ? how can I add picture to pcb ?
Electronics Forum | Tue Mar 02 22:40:52 EST 2004 | pdeuel
To clean up other replys I will add that some most all machines have global correction. Most placements are an off sets from pcb 0,0 usually the lower left corner of the board. When the machine locates the fiduitals and these fids are not exactly whe
Electronics Forum | Mon Mar 01 20:53:28 EST 2004 | Ken
How does a fiducial work? I am going to venture a guess as how it ralates to the parts you are trying to place... A PCB fiducial is a landmark. The fiducial tells the machine where the board is located in the machine. A single fid can only deter
Electronics Forum | Wed Aug 17 15:30:56 EDT 2005 | DannyJ
Hi Jaya, Here's a definition, towards the bottom of the listing... http://en.wikipedia.org/wiki/Fiducial Mainly, a 'global' fiducial refers to the outside of the board, usually on the scrap rails. This allows the machine to locate two reference
Electronics Forum | Sat Dec 11 11:01:11 EST 1999 | Mark W.
In answer to your question no. Fiducials should always be as far apart from each other in both directions (X,Y) as possible. This will allow ANY placement machine to calculate the EXACT location and rotation of the PCB, and therefore correct the moun
Electronics Forum | Tue Jan 09 01:39:41 EST 2018 | jaisabaigroup
Is there any regulation I can check on the Solder mark thickness specification? Or it is depends on PCB manufacturer's design.
Electronics Forum | Tue Jan 09 08:36:17 EST 2018 | pavel_murtishev
IPC-SM-840. If overall thickness is not specified in purchasing documents, a supplier will do whatever it wants. Specify your requirements. Typical values are 20-50um. Regards
Electronics Forum | Thu Jan 11 04:23:08 EST 2018 | jaisabaigroup
IPC-SM-840. > > If overall thickness is not > specified in purchasing documents, a supplier > will do whatever it wants. > > Specify your > requirements. Typical values are > 20-50um. > > Regards Thank you very much, Pavel.
Electronics Forum | Tue Jan 30 08:21:02 EST 2007 | GS
Please who can help me? I am looking for fiducial (cross shape) mark (target mark? Swiss mark?..)specifications used when COB wire bonding on PCB laminate. Pad pitch should be 250umm may be 220umm?). Mainly need to know which are the tolerances
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
