Electronics Forum | Wed Jun 03 21:35:25 EDT 1998 | Mike H
Looking for vendors of splicing tape for 8,12 and 16mm tape and reel. Any net sources?
Electronics Forum | Sun Sep 12 21:08:07 EDT 2004 | mksslcheng
Could someone recommend me the manufacuter who is produce Kapton tape or Alum. tape or Epoxy ,I want to profile wave soldering .You would be appreciated if you can provide its website .
Electronics Forum | Wed Jul 01 10:32:01 EDT 1998 | Eric Klaver
| How can I reach Tesa? I've tried to find a website that contains some useful information but no luck. | By the way, Siemens has stonewalled me regarding their tool/material. Seems to be reserved for Siemens | users exclusively. Joe, The address
Electronics Forum | Thu Jun 04 11:13:39 EDT 1998 | Justin Medernach
| Looking for vendors of splicing tape for 8,12 and 16mm tape and reel. | Any net sources? Mike, Give Siemens a call. They have a decent little system. It's comprised of thin metal fasteners that hold the carrier tape together via the holes, a crim
Electronics Forum | Wed Jun 10 19:53:01 EDT 1998 | Joe Herz
| The Tesa company delivers Splice Tape for 8mm, | 12mm and 16mm. Also special splice tape for 8mm | paper tape and some splice tools as well. | Siemens uses for large tape a 'staple' but might | be patented and then cannot be used outside Siemens.
Electronics Forum | Wed Jun 10 22:19:31 EDT 1998 | Dave F
| | The Tesa company delivers Splice Tape for 8mm, | | 12mm and 16mm. Also special splice tape for 8mm | | paper tape and some splice tools as well. | | Siemens uses for large tape a 'staple' but might | | be patented and then cannot be used outsid
Electronics Forum | Thu Aug 27 12:49:20 EDT 1998 | Frank S.
Where can I find a good tool to splice 8mm and 12mm paper and plastic part carrier tapes together?
Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Wed Jan 22 10:24:23 EST 2014 | cyber_wolf
No matter how good your process is, you will get solder on the gold fingers/lands unless they are protected. We have proven that solder will get on the gold fingers in the reflow oven. How that happens....we arent't 100% sure...there are a lot of the
Electronics Forum | Wed Oct 10 20:35:17 EDT 2001 | djarvis
Stephen, I don't understand this at all mate. 1. If you don't place a QFP and get bridging across the bare pads, you were gonna get absolutely horrendous bridging if you did put one down. That points to poor printer set up or stencil design or both
