Electronics Forum | Thu Oct 10 17:32:52 EDT 2013 | soscomputer
you're right for sure, but there is some brand like hakko i don't like them why ? because process and menus (controllers) doesn't really give a good result. For example fm206, hot air/desoldering/soldering station doesn't have the real tc. And a lot
Electronics Forum | Thu May 01 17:38:06 EDT 2008 | ldbepurchase
www.ldbepurchase.com
Electronics Forum | Tue Mar 19 13:22:13 EDT 2019 | lapskrfc
Dear all, I'm considering to buy a nice rework station for our lab. We are not gonna do mass production and the smallest components that we will be soldering is in the order of 0201 smd components. Actually, I'm considering the following three machi
Electronics Forum | Fri Jun 23 12:11:26 EDT 2017 | rgduval
I haven't tried doing these, personally...but... - Try a pre-heater? - IR rework station? Off the top of my head, that's all I've got. Cheers, ..rob
Electronics Forum | Fri Jul 07 16:52:20 EDT 2017 | tombstonesmt
We had very little success reworking these type of boards. We used a BGA repair station and still was a major hassle. Are these shifted LED's or defective?
Electronics Forum | Thu Nov 16 23:34:56 EST 2006 | mds33200
Hi, I am new in this industry and have purchased a beguinner unut, a 3-in-1 solder, desolder, hot air station. Currently I work on cellphone mainboards. At the moment I only replace single large chips on the mainboard. I would like to be able to repl
Electronics Forum | Fri Nov 17 15:12:26 EST 2006 | mds33200
Hi, I am located in Auburn Mass (USA) right near Worcester. Now I noticed you talked about micro stencil for a populated PCB, would I need one? Or could I use a syringe to lay a tiny dot of paste since im only replacing a chip or 2 (at the moment)? I
Electronics Forum | Fri Jan 08 15:02:38 EST 1999 | Dave F
| HI! I am a package engineer in Korea. I have some reasons | to desolder excessive solder at the lead of TSOP and TSOJ | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | Does anyone
Electronics Forum | Tue Mar 25 02:58:24 EDT 2014 | molder
ok.. thanks you so much.. I will buy new dispenser siringe, and I try to rework... I have a questions on desolder and solder a socket 1366 intel on motherboard. I have a rework station Honton hot air and tornado infrared, but i don't know a temperatu
Electronics Forum | Fri Jan 08 19:47:55 EST 1999 | Kwang-Seong Choi
| | HI! I am a package engineer in Korea. I have some reasons | | to desolder excessive solder at the lead of TSOP and TSOJ | | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | | Does
