Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Fri Sep 15 14:29:10 EDT 2006 | bvdb
Thanks "j". There is absolutely no support for Fuji in New Zealand or for the older IP-1 and MCS/2 programming computer. We got the machine working by studying the FIP-1 Operation Manual and the MCS/2 Programming manual and a lot of trial and error
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Thu Aug 02 14:27:28 EDT 2007 | slthomas
We're having problems figuring out how to optimize our stick feeders. We want to keep them all on the back side but the only way we've been able to get the data generator to finish optimizing without errors is to make all feeders movable, and it send
Electronics Forum | Sun May 27 22:36:25 EDT 2018 | fadzril
Hi! I would like to inquire if anyone occurred the following error for Sony SI-G200? Error : The upper pusher return sensor is not on. Alarm Code : 410000607 Recovery Method : Re-optimize the program There's a grey area between machine & program.
Electronics Forum | Mon Aug 06 13:05:19 EDT 2007 | gemengr
Try this... set them on the back and teach their pick up position as stick feeder, change pick up rotation to -90 degree. before you optimize the program, change them to 8mm feeders , them optimize the the program as feeder fix. after the program
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Fri Apr 11 15:14:36 EDT 2014 | superlen
CP45 as fast and error-free as possible, but it's tightly integrated to our MRP backend and not easily separated. It also doesn't let you pull back out the optimized feeder list as I haven't tried to reverse engineer the .pcb or .opt file. I've looke
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
.gif)
winsouce.jpg)