Electronics Forum | Sat Sep 22 10:07:28 EDT 2018 | davef
This chart is from http://www.nordson.com/-/media/Files/Nordson/asymtek/Papers/Process%20Control%20and%20Traceability%20in%20Automated%20Conformal%20Coating.pdf?la=en
Electronics Forum | Thu Oct 22 15:10:00 EDT 1998 | Chris Fontaine
| I'M LOOKING FOR A SOLVENT TO MAKE REMOVING EPOXY FROM THE BOTTOMSIDE OF BOARD ON SMT COMPONENTS. THIS IS MOST IMPORTANT AFTER THE EPOXY HAS CURED AND EVEN RAN THROUGH THE WAVE. I'M LOOKING FOR A WAY OF | MAKING THE REWORK PROCESS ON THE CURED EPOX
Electronics Forum | Fri Jan 04 17:15:54 EST 2002 | Mike Konrad
Eliud, You will most likely not find a local Culligan / US Filter office willing to provide regeneration services. The most cost effective method is to use DI tanks that are user refillable in the field. With user refillable tanks, you need only e
Electronics Forum | Wed Aug 30 10:13:12 EDT 2000 | Kevin Hussey
Hi Francois, There are a lot of nice cleaners out there. The one thing I wanted to point out is to be careful when ordering one machine for both glue and paste. Some machines requires special rubber o-rings when using glue thinner (esp Loctite).
Electronics Forum | Thu Mar 15 16:58:11 EST 2001 | mparker
The only way I know of waving the bottom side with SMT parts installed without epoxy would be to use a masking media, Kapton Tape, wave pallet that keeps those parts from being susceptible to gravity once the connections are reflowed. If there is ano
Electronics Forum | Wed Nov 11 07:12:45 EST 1998 | Mohamed Ragai
Dear SMTNETers, I need help in the following subject : Copying of a pre-programmed master EEprom DIP 8 leads from AMTEL to many other IC's ( Gang Copier ), without using any PC media, in other words ,i need the old style cheap IC copier(and NOT
Electronics Forum | Thu Jul 16 14:29:00 EDT 1998 | Aric Parr
Contact me off-line. I inherited 4 of them. I cannot make recommendations in recorded media. However, yield is very good when PM is done properly. | Howdy, | Is anyone using Seho? Need to know more about 7000 series machines with nitrogen and ultraso
Electronics Forum | Wed Apr 03 11:55:09 EST 2002 | Fuji Spares
If you require a prgram to control the documentation of the ECN process - I would reccomend this company they helped out our process no end by writing a customised Microsoft Access based database visit this site:- http://www.tekno-media.com also i
Electronics Forum | Sun Jan 25 15:07:14 EST 2004 | davef
No one handling floppy disk should have a magnet on his or her wrist or in their work area. Furthermore, those with a magnetic paperclip holder on their desk should not allow floppy disks to come in close proximity to it. Since only technicians handl
Electronics Forum | Fri Jun 22 14:16:28 EDT 2007 | patrickbruneel
I agree with the down to earth, low tech but very effective peace of card board and is far better then trying to measure Mg/Inch sq with a volatile media. The only addition I would like to make to �Real Chunk�s� advice is: Dry spots on the cardboard