Electronics Forum | Thu Aug 20 09:19:19 EDT 1998 | JUSTIN MEDERNACH
| Require a conductive adhesive - either isotropic or anisotrpic - which can be used for 100micron oitch devices. | Must be resistant to solvents such as MEK and acetone. | Cure below 150C, with possible potential for rework of the conections. MR. T
Electronics Forum | Wed Aug 19 06:40:06 EDT 1998 | G Thomas
Require a conductive adhesive - either isotropic or anisotrpic - which can be used for 100micron oitch devices. Must be resistant to solvents such as MEK and acetone. Cure below 150C, with possible potential for rework of the conections.
Electronics Forum | Sat Aug 22 16:07:31 EDT 1998 | Manuel Cornejo
| | Require a conductive adhesive - either isotropic or anisotrpic - which can be used for 100micron oitch devices. | | Must be resistant to solvents such as MEK and acetone. | | Cure below 150C, with possible potential for rework of the conections.
Electronics Forum | Tue Feb 07 12:26:14 EST 2017 | westshoredesign
Oh yeah, so we have a auger valve similar to that on one of our other machines that we use for dispensing SMT glue, and solder paste also. We have a conditioner that we flush it with at EOD when in use, then we just let it sit idle with the condition
Electronics Forum | Mon Aug 24 08:44:52 EDT 1998 | Justin Medernach
| | | Require a conductive adhesive - either isotropic or anisotrpic - which can be used for 100micron oitch devices. | | | Must be resistant to solvents such as MEK and acetone. | | | Cure below 150C, with possible potential for rework of the conec
Electronics Forum | Tue Dec 20 10:10:21 EST 2005 | SteveH
Ours is the same configuration as that, we run with neat Humiseal 1B31 through the needle valve and a 1:1 blend 1B31/Butanone (MEK) in the spray valves. Programming is done via a PC using the pendant and the path is point to point trained on scrap P
Electronics Forum | Tue Mar 27 18:37:10 EDT 2007 | gregcr
I'm actually in the process of phasing in direct inkjet marking on my bare boards. The MEK based inks dry almost on contact, and the machines I have use a videojet excel HD printhead. I'm looking forward to see how it works for us. I think it may
Electronics Forum | Thu Jan 28 15:53:12 EST 1999 | Dave F
| | Hello Netters, | | | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI
Electronics Forum | Thu Jul 15 21:26:01 EDT 1999 | Scott McKee
| I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | What is it you're trying to do? Dealing with chem
Electronics Forum | Fri Jul 16 13:49:31 EDT 1999 | Timothy O'Neill
| | I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | | | What is it you're trying to do? | Dealing w
winsouce.jpg)
.gif)
