Electronics Forum | Wed Oct 12 12:05:17 EDT 2011 | dphilbrick
It melts many plastics but not harmful to electronic components. to use it properly you need a vapor degreaser.
Electronics Forum | Fri Nov 02 03:26:40 EDT 2012 | spopov
Hello! We want to try Lead Free paste Sn42/Bi58. Can we use this paste with Lead fihish such as HASL. I am worry about low melting temperature of 138C.
Electronics Forum | Fri Jan 18 08:08:24 EST 2013 | cyber_wolf
I have a 5lb roll of .125" flux core 63/37 solder that I want to melt into a solid slug. Can this be done without making a huge mess and lighting something on fire ?
Electronics Forum | Wed Mar 20 09:54:11 EDT 2013 | patrickbruneel
Seal and peel would be the solution to your curing time problem. It’s a thermoplastic hot melt which air cures as quick as 30 seconds. http://www.interfluxusa.com/Datasheets-PDF/Seal-and-Peel-(DSRev08).pdf
Electronics Forum | Wed Jul 10 14:29:27 EDT 2013 | isd_jwendell
You wouldn't have a very good profile if you went straight from room temp to vapor temp (_-). The chamber should preheat the board before using vapor to melt the solder.
Electronics Forum | Mon Apr 07 13:12:02 EDT 2014 | cyber_wolf
Gary, We are missing something here. I see no evidence of reflow at all. If you have a thermo couple under the inductor, 237 deg with a TAL of 48 seconds should work all day long.(even though it may be on lower end of process window) SAC melts at 21
Electronics Forum | Tue May 13 07:04:54 EDT 2014 | hemant_pang23
I am looking for the solder wire leaded or lead free which can withstand the solder joint at temperature 450deree Celsius or more after soldering, since i need to form a solder joint at higher temperature area Pls suggest the part number for the sam
Electronics Forum | Tue May 13 07:40:14 EDT 2014 | sarason
There are many alloys of silver solder for higher temperatures mostly used in plumbing There are also alloys which are available in paste form used in the manufacture of hybrids. sarason
Electronics Forum | Wed Oct 22 14:55:00 EDT 2014 | rrosera
Does anyone have any experience with labels capable for withstanding both re-flow and machine wash cycle? We've tried a few different materials and the ones that make it threw re-flow wash off and the ones that make it threw was tend to melt in re-fl
Electronics Forum | Thu Aug 27 11:18:05 EDT 2015 | dyoungquist
From your description I am assuming you are doing double sided reflow and parts are dropping off the bottom side when the board is run through the reflow oven the second time. A few ideas to try: 1) Are the parts that are dropping off heavier parts
