Electronics Forum: memory card cp 643 (Page 1 of 1)

Anyone experianced with FUJI PCMCIA Flash Memory cards

Electronics Forum | Tue Feb 01 16:56:46 EST 2022 | rstellema

Hello all, I have a couple of old FUJI CP-6 SMT placement machines that are operating with very old PCMCIA Flash Memory cards. I would like to insure that I have back-ups should the memory cards fail. I assume that I would need a support USB reader/w

Buying Used High Speed Equipment

Electronics Forum | Wed Apr 03 13:32:30 EST 2002 | Bob

Hi, Just to ease your mind a little. I have 15 years experiance on Fuji kit, and was the engineer in charge of over 30 CP6's. They are very robust and the electrical / electronic side is pretty bomb proof. The main thing to look out for is wear in

CP643E, vision ststem alare

Electronics Forum | Tue May 24 05:25:17 EDT 2005 | Zsolt

We had similar problem, the root cause was that the cooling fans on the VME rack were not working and the vision card hangs up if the temperature is too high. Also check the power supplies, we had also a problem that the filter condensator inside the

FUJI CP3 PROBLEM

Electronics Forum | Mon Apr 15 20:44:00 EDT 2013 | dman97

So I swapped the memory card out and it seems to be a bit better. It doesn't kill the 24v power quite as much anymore. Thanks for the tip. I will monitor this throughout the week.

Recomendations? Fuji CP7 or Univ HSP4797?

Electronics Forum | Wed Jun 23 10:26:53 EDT 2004 | exmaintenanceleader

Grant and all! CP-2 is the oldest fuji as I have been operated. CP-3 is built in 1989 as a new mc. Now 15 mc I now they runs in 3 shift widouth problems when they need countinous runing comes the problems. conroll card and relay contact problems at

Camera Problem on CP6-4000

Electronics Forum | Mon May 06 02:30:25 EDT 2002 | dszeto

We have continual vision process error 1CB02003 on narrow view camera during nozzle centering measurement. The wide view camera works properly. So far we have done the following things to rectify the problem but the problem still exists: 1. Replac

Fuji PAM measure

Electronics Forum | Fri Sep 16 12:52:13 EDT 2005 | timekey

Steve- Depending on which Fuji model you have, Fuji PAM either needs to be purchased from Fuji or if you have a CP-7, CP-8 or NXT, Fuji PAM is already installed in the machine from the factory. The kit...if you are required to purchase it from Fuji i

  1  

memory card cp 643 searches for Companies, Equipment, Machines, Suppliers & Information

PCB Handling Machine with CE

Training online, at your facility, or at one of our worldwide training centers"
SMT feeders

Wave Soldering 101 Training Course
SMT feeders

High Precision Fluid Dispensers
Software for SMT

Best Reflow Oven