Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Fri Apr 12 08:51:12 EDT 2019 | kgarlapa
We are using kanetic conveyor 13inch size. The conveyor belt moves reverse direction when pcb comes. what could be the problem?
Electronics Forum | Tue Apr 16 15:51:34 EDT 2019 | kgarlapa
we don't have a jumper shunt in this conveyor. This conveyor belt running forward direction since 5 years but all of sudden change to reverse direction. Is this any software issue? Note: Both side sensors are working fine
Electronics Forum | Tue Apr 16 13:01:10 EDT 2019 | slthomas
Is it possible that the conveyor controller card has the capability to switch direction with something simple like a jumper shunt?
Electronics Forum | Tue Apr 16 13:32:36 EDT 2019 | slthomas
Another question: After the conveyor starts running, when you trip the sensor at the other end, does it stop running?
Electronics Forum | Tue Apr 16 19:59:32 EDT 2019 | davef
Tel: 0115 955 4506 Kinetic Conveyor & Roller Systems Unit 2 Enterprise Park Wigwam Lane Hucknall Nottingham NG15 7SZ Email: sales@kineticbelting.co.uk
Electronics Forum | Wed Apr 24 21:45:33 EDT 2019 | aksaustin
If you look in the back of the panel there should be some type of VFD drive that controls the conveyor motor. You may be able to control rotation that way depending on the manufacturer. Should be able to google the VFD mfg and find a manual online,
Electronics Forum | Fri Apr 12 18:10:57 EDT 2019 | davef
Here's what we've done in the past. Depending on how it's configured, conveyors can run either forward or backward, but only in one direction at a time. The voltage polarity through the starter of the drive motor configures the direction. So, swappin
Electronics Forum | Wed Apr 17 08:01:42 EDT 2019 | jfeustel
If this is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois then I've seen this before. The folks at Kanetic built a function into the PLC code to make the conveyor reversible without hardware modifications.
Electronics Forum | Mon Apr 22 14:06:25 EDT 2019 | kgarlapa
Yes it is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois. I tried holding the reset/start button and also tried to cycle the power after after holding the reset button, No Luck.Do you know if Kanetic is sti
winsouce.jpg)
