Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Thu Sep 08 20:28:26 EDT 2022 | emeto
Rotate Midus by hand and see if it is bent.
Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou
Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Fri Jan 05 16:16:51 EST 2024 | mistrthou
Based on the my15 we used to have and our current My100's I'd say it lost the position of the tool bank. Is it Hydra or Midas tooling? Uninstalling and reinstalling the hydra tool bank is fairly easy. If it's Midas tools, does it fetch other tools
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
