Electronics Forum | Sat Nov 20 12:10:37 EST 2021 | bk
Yes, you can run tm magazines on my machines but with the hydra heads they are not quite as accurate and miss pick more parts then agilis feeders. Mycronics does sell dual head machines with 2 midas heads and 2 sets of hydras
Electronics Forum | Tue Nov 23 02:23:27 EST 2021 | SMTA-64387687
The TM magazines will work exactly the same on the newer machines, as they did on your TP-11. The MY100, MY200, and MY300 series machines are all available with 2 heads, Midas and Hydra.
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Sun Jan 24 20:11:45 EST 2010 | wmeliane
Hi I would like to get feedback on which of the following 2 machines to buy: -option 1: My100 with single Midas head -option 2: D1S with single P&P head I have experience with the Siemens D series. However I have no real experience with Mydata... Is
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Wed Jul 11 06:10:17 EDT 2007 | chrispy1963
I have read through the solutions the other techs have mentioned, however, I have a couple more thoughts to offer you when you have these kinds of problems. 1) If you are using a C14 tool it is a spring tool and thereby it utilizes the "Force Sensor
Electronics Forum | Thu Sep 17 10:18:54 EDT 2015 | huske
What model do you have? Are you working with a Midas only or Hydra as well? Are you looking for basic information on how to get started with chips and SO's? Or like how to use auto-teach or manually measuring parts and programming or more like select
Electronics Forum | Wed Feb 25 15:16:56 EST 2015 | dyoungquist
We have MY12 and MY15E machines. I am going to assume what we are seeing also applies to the MY100 series machines as well. Do you have the electrical verifier option that works with the midas head and centering jaws to check component values of
Electronics Forum | Tue Feb 18 14:46:38 EST 2020 | bilalfarooqi
Hi all, We were able to fix the issue. We replaced the MOT cards with the MOT cards in the good machine. That, however, did not resolve the issue. The issue was very basic; one of the fuses (fi fuse) located to the left of the MOT cards became open.
winsouce.jpg)
