Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Sat Nov 20 12:10:37 EST 2021 | bk
Yes, you can run tm magazines on my machines but with the hydra heads they are not quite as accurate and miss pick more parts then agilis feeders. Mycronics does sell dual head machines with 2 midas heads and 2 sets of hydras
Electronics Forum | Fri Mar 24 11:28:10 EDT 2023 | cyber_wolf
We replaced at least 4 Hydra heads, 3 midas heads, vacuum pumps, line scan cameras under warranty back in the day. I have worked with Juki 2060 and 3010 series. Whomever is telling you they are bad machines doesn't know.
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Tue Oct 25 15:03:48 EDT 2011 | sjs2303
Hi Bert, For your second issue, are the tools well lubricated? If not the Midas head can fail to grab the tool and can generate the z motor error. Doing this followed by a base-centre level measurement should resolve your problem. Steve
Electronics Forum | Wed Jul 18 14:55:30 EDT 2012 | mikesewell
We bought from Mydata and recently had a new Midas head put in by Mydata and I've been on the phone with tech support. This has been a intermittent issue that's been hard to pin down.
Electronics Forum | Tue Aug 28 11:03:40 EDT 2012 | mikesewell
The problem is still intermittent. It has a new MIDAS head, installed and calibrated by Mydata, FWIW. Usually we work around it by moving parts upstream (Fuji AIM). I'll post an update when I finally chase the issue down.
winsouce.jpg)