Electronics Forum | Fri Sep 18 08:58:51 EDT 1998 | Wendy Casker
Good Morning, I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. Thanks, Wendy
Electronics Forum | Mon Sep 21 09:03:08 EDT 1998 | Greg Curler
| Good Morning, | I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. | Thanks, | Wendy Wendy, We are pr
Electronics Forum | Thu Sep 24 20:12:13 EDT 1998 | Dave F
| Good Morning, | I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. | Thanks, | Wendy Wendy: You're en
Electronics Forum | Wed Sep 23 15:06:16 EDT 1998 | Dave
| Good Morning, | I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. | Thanks, | Wendy Wow, What a blast
Electronics Forum | Fri Sep 18 21:37:50 EDT 1998 | Jeff Sanchez
| Good Morning, | I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. | Thanks, | Wendy Mill-Max
Electronics Forum | Tue Mar 30 12:56:42 EST 2004 | Robert
Looking for trays that can hold Dual in Line Sockets that come in 24pins and 28 pins. The parts are from Mill-Max numbers 214-99-624-01-670800 and 214-99-628-01-670800. I get these in tubes but need them on trays. If anyone uses these parts or SMD
Electronics Forum | Wed Jan 04 18:20:25 EST 2017 | ttheis
We recently ran a board with Mill Max surface mount spring-pins which placed perfectly straight from tape/reel but came out tilted in various directions after reflow. We're right within the recommended paste thickness of 0.005" and a reflow temperatu
Electronics Forum | Fri Sep 21 13:04:58 EDT 2007 | jmelson
Hello, Is anyone using an SMT pick&place machine to insert single contacts into PC boards? I have some boards that have 32 female contacts for 1mm pins, and 16 contacts for 0.5mm pins. I have been using Mill-Max for these contacts, getting the sma
Electronics Forum | Fri Jan 26 08:44:40 EST 2007 | dsteffler
Had the same thing happen here. If the thermocouple line shorts out the temperature appears to go runaway (999F or whatever the max of your software is). Ours was a short out in a socket where the thermo plugged in to pass through the frame. Regar
Electronics Forum | Wed Sep 08 04:10:14 EDT 2021 | leeg
Thanks Davef, we are using a mill max pogo pin on a small pcb that is panelised into a panel of 50, we have had a jig designed to get them straight instead of hand placing, there are 4 per pcb. We have followed the manufacturers guidance for stencil
