Electronics Forum | Thu Mar 24 18:29:36 EST 2005 | SuePH
Thanks for the reply, Russ. I looked at the Air-Vac web site. I am looking for something that is a lot more basic than their machine. I had seen a small table top wave machine at a customers shop a few years ago. It had a pump and different si
Electronics Forum | Fri Mar 25 09:11:17 EST 2005 | russ
A long time ago I used to have one of these machines that was very simple (no ramp control, etc... like the Air-Vac) and it was made by electrovert which is now speedline, I don't know if this is still in production however. You may want to try anyw
Electronics Forum | Thu Mar 24 17:37:35 EST 2005 | SuePH
Am looking for a table top mini wave to remove connectors or solder in connectors in hard to reach areas. Can anyone recommend a good brand. Thanks
Electronics Forum | Wed Apr 13 15:03:05 EDT 2005 | haviland
Am looking for a table top mini wave to remove > connectors or solder in connectors in hard to > reach areas. Can anyone recommend a good brand. > Thanks Hi--We have a couple of Wenesco Rework units, (1) for SMT and the second for PTH. These ar
Electronics Forum | Sat Aug 23 12:47:54 EDT 2008 | bruna
Hi! Does any one can give the reason of the black dust into de wave solder machine. We can found no reason for that, but the machine get dirty to fast despite the maintenance. Thanks for your time Bruna Neto
Electronics Forum | Tue Aug 08 12:49:33 EDT 2023 | serge_pirog
I ask for advice on starting wave soldering machine. The soldering machine is not new. Are there guidelines for properly loading solder into a bath and more. I also ask you to recommend an alloy. What do you think about Alpha Sn Plus 07 or SN100C(Sn
Electronics Forum | Mon Aug 25 08:33:59 EDT 2008 | lococost
That's just dross. If you have nitrogen blowing over the wave, you could reduce its flow as it tends to blow the dust everywhere if it is set too high. (on the other hand it might reduce solder quality)
Electronics Forum | Wed Aug 27 16:31:45 EDT 2008 | bruna
hi loco, Thanks for your post, it was very helpfull.
Electronics Forum | Thu Aug 10 08:26:42 EDT 2023 | serge_pirog
Heeb inotec HWL 330
Electronics Forum | Tue Aug 08 20:39:29 EDT 2023 | cbeneat
What manufacturer is it? I usually stack the bars in as tight as possible. Especially against the wall of the pot with heaters. While it's heating keep applying slight pressure with a bar of appropriate material, towards the sides to facilitate melti
