Electronics Forum | Wed Jun 26 13:42:14 EDT 2013 | nucleus
Hi, we just bought a used dek infinity 265. Unfortunately we cannot find a programming manual. We have two big technical references and a operator manual. Is there someone who has a pdf-version of the programming manual? Thanks! Best regards mts
Electronics Forum | Thu Dec 08 19:10:11 EST 2005 | Robert
Alan, I got that message before it come to the main screen so i could not reinstall the Mint program. Regards
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Wed Nov 21 00:14:25 EST 2018 | leeg
As Dekhead has said, sounds to me like you have the wrong setting in your screen choice within the program, is it edge or centre justified?
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Mon Feb 02 13:14:11 EST 2004 | kauer
Hey, going to lunch now. Just for kicks, did you try to re-load Mint files? They may have been lost some other way, I have seen the DEK software do some crazy stuff in the past. Talk to You in a bit.
Electronics Forum | Wed Dec 07 22:39:03 EST 2005 | Alan
Robert, you will have to re-load the MINT software. It only takes a couple of minutes to do this. This will fix out the errors. Refer to your DEK manuals on how to carry out this function. Cheers, Alan.
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re