Electronics Forum | Mon Jan 11 12:25:03 EST 2021 | gfe
Feeders Mirae error code E1, don't do the steps, what's the repair
Electronics Forum | Mon Jan 11 12:27:12 EST 2021 | gfe
Feeders Mirae error code E1, don't do the steps, what's the repair
Electronics Forum | Thu Apr 30 04:54:06 EDT 2020 | gfe
Hello work staff , i have a error on Mirae CODE: 1035 Mensage says (THE TEMPERATURE OF FRONT X IS TOO HIGH! Does anyone know how I can solve this problem? Tanks ;)
Electronics Forum | Wed Nov 06 12:58:56 EST 2013 | bobpan
The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z positi
Electronics Forum | Thu Jan 09 08:40:37 EST 2020 | raeesrajput
Hi Every one, Thanks in advance for your help and support. I am getting errors 'Nozzle pick up error' and 'Nozzle release error' on Mirae Mx350. I have been told to calibrate Nozzle Holes using 'ANC' option in the Menu. Ther
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Thu Jun 29 10:19:34 EDT 2023 | gfe
Hello, I have a problem with the mirae mx200l, the Y1 servo has error 38, does anyone know how to fix it?
Electronics Forum | Thu Jun 29 12:36:12 EDT 2023 | tommy_magyar
Found this h ttps://www.manualslib.com/manual/1947318/Mirae-Mx-Series.html?page=392#manual There is a section for errors. Hope it helps.
Electronics Forum | Thu Apr 30 05:22:40 EDT 2020 | bobpan
There is a sensor that monitors the temperature of the x and y1/y2 axis on the machine. You have a possible problem with the x temp sensor. There is also a temperature board that is located in the leg area below the keyboard. I am attaching a picture
Electronics Forum | Mon Aug 22 08:54:15 EDT 2016 | bobpan
More than likely the encoder scale or read head has an issue. Many times.. oil/dirt/water get on the scale and cause a bad spot or bad area. Try to clean the scale with a lint free cloth and alcohol. You should also be able to see the read head and m
winsouce.jpg)
