Electronics Forum | Mon May 16 03:37:51 EDT 2016 | wesleyintelli
Update to the above. I swapped the swing mirror motor and cable across from our other Cp45 machine and the system homes correctly. It seems the second hand replacement motor may have been taken from the conveyor width adjustment assembly of another m
Electronics Forum | Mon May 16 00:33:18 EDT 2016 | wesleyintelli
Our CP45 swing mirror motor (Panasonic AC Servo Motor: MSMA012A3A) recently jammed and required replacement. I replaced the motor with a new one however it won't home. A link to a video of the motor attempting to home can be seen below. I am wonderin
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Thu Aug 12 15:39:36 EDT 2021 | bukas
it can be cable. can you swap cables with next driver? also swap cables on head. if same driver shows error you need new driver probably. if new driver shows error then its cables or motor. check documentation to see what motor it drives. you cant sw
Electronics Forum | Thu Mar 21 02:52:59 EDT 2019 | bukas
looks like home sensor problem, whats the error message? does head 6 now work properly?
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
.png)
.jpg)