Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Fri Dec 09 01:05:11 EST 2022 | varun
We have a Mirtec MV-3U AOI machine. Can someone help me to find a way on how to save the image of the board along with the report after the inspection is complete? Currently it only saves the report with the errors showing on the template image which
Electronics Forum | Tue Oct 03 18:13:46 EDT 2023 | glasscake
Its ether going to be in the settings before launching the software at the login screen or the settings after launching the softer on the top right. You should see some tab relating to defects. There should be a setting that says something along the
Electronics Forum | Fri Apr 21 18:43:23 EDT 2006 | SD
Sorry, I have not read the article. However, I do have five years experience constantly tweaking an AOI system that ran ONE product! The strength of the machine was solder inspection. The biggest problem was component color variation and shadowing
Electronics Forum | Wed Oct 29 14:13:48 EDT 2008 | andrew_11
Hello Dominik, I recently ended up purchasing a MIRTEC MV-3 AOI System. In looking at different manufacturers I realized that there were two philosophies to inspecting boards, Image based and Rules Based. When I explored both technologies I found ou
Electronics Forum | Wed May 09 05:54:51 EDT 2012 | pvasquez
Hello thomas31, When we did our equipment evaluation, we looked at all of these systems with the exception of Goepel. My team and I thought that the image quality of the Mirtec machine was by far the best of any of the other vendors. We also found t
Electronics Forum | Wed Aug 17 10:32:44 EDT 2016 | haqtien09590
Im from Vietnam. Can you introduc for me by image?
Electronics Forum | Thu Dec 23 11:44:16 EST 2010 | vpblf
I have experienced the same issue with the repair plus software not saving or displaying images properly when the defects are being reviewed. Have you asked Mirtec about it? What did they tell you? Curious to know.
Electronics Forum | Tue Nov 07 14:23:13 EST 2006 | CL
Hello bpeach, We purchased a Mirtec for our first AOI machine after a side by side comparison of three different manufacturers. The Mirtec proved to be far superior to the others that we had looked at. Initially, the intention of the AOI was to prov
