Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Wed Jan 15 15:25:41 EST 2025 | SMTA-64385908
Hello Charlie, MIRTEC Offers machines that can inspect that size PCB. MIRTEC has the capability to inspect a PCB up to 1,600mm. Feel free to contact Robert Horowitz @ 203-217-0271 or via email r.horowitz@mirtecusa.com.
Electronics Forum | Fri Dec 09 01:05:11 EST 2022 | varun
We have a Mirtec MV-3U AOI machine. Can someone help me to find a way on how to save the image of the board along with the report after the inspection is complete? Currently it only saves the report with the errors showing on the template image which
Electronics Forum | Thu May 26 06:59:06 EDT 2005 | CLampron
Good Morning, We have several Mirtec table top machines. We bought the first one when it was under the Samsung name. We had the advantage of doing a side by side comparison with several other systems. The Mirtec was the leader in performance. Since
Electronics Forum | Tue May 22 07:55:05 EDT 2012 | rway
Although not listed in your post, I recommend YesTech. I have been using them since 2007. We have two M1 systems, and they have been good machines. We evaluated three: YesTech, Mirtec, and Christopher. Of the three, the YesTech system caught more
Electronics Forum | Tue Aug 26 16:24:18 EDT 2008 | rway
We currently use a YesTech M1 system and we are looking to buy another. Two important areas to look at when pursuing AOI equipment: 1) Camera resolution 2) Light sources Depending on your needs, camera resolution can be important depending on the si
Electronics Forum | Wed Apr 23 10:19:53 EDT 2008 | mikesewell
Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've
Electronics Forum | Thu Jan 18 09:11:35 EST 2007 | AR
Hello Chris, Are you inspecting wave soldered boards as well with the Mirtec? I hear that inspecting wave soldered boards is so much more complicated than reflowed boards, no doubt due to the varying shapes of even perfectly acceptable solder joints
