Electronics Forum | Thu Jul 27 10:45:12 EDT 2017 | georgetruitt
Does the Mirtec inspect the solder joints top/bottom of the through hole as well as the color value?
Electronics Forum | Thu Jan 13 20:40:47 EST 2011 | eadthem
properties > settings > troubleshooting > Set hardware acceleration to NONE > apply OK apply OK reboot. without this any attempt to take a screen shot of the program will not save the image (because in a fruitless attempt to speed it up they have pr
Electronics Forum | Sat Nov 08 16:55:22 EST 2008 | rway
I think you'll find that the YTV-F1 system is comparatively priced at around $100K. Plus it has a color camera and more functionality than what you will get with the Landrex system. You might also look at what Mirtec has. I have only used them for
Electronics Forum | Thu Aug 08 11:39:53 EDT 2024 | stephendo
I used an early Mirtec about 20 years ago. I think none of us had previous experience with AOI at the time. We of course had a learning curve abut Mirtec was great with support. But we had trouble with false fails and part of the problem was bad imag
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Wed Nov 03 12:08:59 EDT 2010 | hegemon
I had an opportunity two years ago to evaluate three benchtop AOI systems. Omron, Yestech, and Mirtec. I was fortunate to be able to have all three machines side by side for my evaluation period, which lasted near a full month. At the time I was
Electronics Forum | Thu Nov 04 19:55:49 EDT 2010 | eadthem
The best method i have for the few lifted/bent lead issues we have is i use a ic/bridge inspector with all its default options to check for bridges and solder at the tip. then i add a solder inspector but this time accrost all pins at the downslope o
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Tue Nov 04 10:47:54 EST 2008 | rway
Thank you all for the great responses. We to looked at tne Mirtec before settling on the YesTech. I felt the machine software was better structured and organized and the system caught more faults on our "broken" board than the other system did (We
Electronics Forum | Thu Nov 04 19:42:21 EDT 2010 | eadthem
We do almost exclusively SMT parts but for solder with a 45 degree fillet angle use vertical light type and a binarise threshold of 128(1/2 dark 1/2 light) and use the 2nd option or dark=dark light=light _|" in vertical light solder fillet is dar
winsouce.jpg)
