Electronics Forum | Thu May 13 01:14:37 EDT 2004 | vincent
hi, i have a question relating to fiducial, is the fiducial normally comes with the pick and place data from the custommer or we have to define it by ourself? how to set its coordinate so that the cp6 and ip3 (using Fujicam software) will be able to
Electronics Forum | Thu May 13 10:14:07 EDT 2004 | Rob
I don't use the machines you have; I'm running a Siemens line. Regarding fiducials, this data should be provided by the design engineers through some kind of mechanical drawings. I usually get this with the CAD data. I don't know if there is a standa
Electronics Forum | Thu May 13 10:43:34 EDT 2004 | rob_thomas
hi, i have a question relating to fiducial, is > the fiducial normally comes with the pick and > place data from the custommer or we have to > define it by ourself? how to set its coordinate > so that the cp6 and ip3 (using Fujicam software) > w
Electronics Forum | Mon Mar 01 13:06:55 EST 2004 | Chris
Hi I have a question about fiducial mark. Can anyone explain me how it is work?. Do you have to during programming set exactly center of the mark? or approximate point the mark and the machine during placemnt will correct it. In some P&P i have met
Electronics Forum | Tue Mar 02 22:40:52 EST 2004 | pdeuel
To clean up other replys I will add that some most all machines have global correction. Most placements are an off sets from pcb 0,0 usually the lower left corner of the board. When the machine locates the fiduitals and these fids are not exactly whe
Electronics Forum | Tue Jun 14 07:29:12 EDT 2005 | jdumont
So I set up a board yesterday and did a test run. It appears that the spacing does matter on my machine. It placed the part off-center the same amount as one of the fiducials. Im going to look more into fixturing and placement pressure adjustments I
Electronics Forum | Tue Oct 18 14:59:35 EDT 2016 | muzzy
Hello. Our company recently bought a Samsung CP40V pick and place machine. It works very well, the software is intuitive but we have one problem. Is there a way to manually set fiducial position after machine failed to recognize it? For example, duri
Electronics Forum | Fri Aug 22 15:26:18 EDT 2008 | rway
I rarely use blk fiducials. But when I do, they are always programmed after the fids. It's the fids that sets your general alignment of the panel. I only use blk fidus for thin pcbs (30 mil) that tend to warp when on the conveyor.
Electronics Forum | Tue Mar 08 09:57:04 EST 2016 | rgduval
Make sure that your fiducials are selected to be used for global correction. I've had this problem with our machine running OS2, and in the UI for that, you have to select the fiducials in the fid screen, and then there's a menu option to select the
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
.png)
winsouce.jpg)