Electronics Forum | Mon Nov 20 14:48:35 EST 2023 | proceng1
Have you reached out to MIRTEC? They can easily connect through Teamviewer and check your settings and see what you see live. It would be way more effective than someone trying to troubleshoot by email. The support tech that we usually get really
Electronics Forum | Mon Nov 20 16:10:58 EST 2023 | kghadiya
I tried to reach them out but our machine is not registered on their site so they asking big amount to register and then support. That's the only reason I am asking for help in this forum.
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Fri Nov 05 18:47:31 EDT 2010 | eadthem
I'm guessing when you say bare board you mean wet paste only? When you say the pads move slightly are your boards warped at all at the Vscore? What we do is use per modual fids. first you delete or don't make panel fids and then theres a option wh
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Fri Jan 11 07:26:07 EST 2008 | laplooi
Hi, me again. Who can tell me which software is availble for the Mirtec MV-2BTL? On this moment we working with Mirtec Inspector 3.4.2/7.50+ is this the only software which is availble for the MV-2BTL?
Electronics Forum | Tue Apr 09 12:08:25 EDT 2013 | zinalnpatel
I am new into the programming of mirtec MV2-HT and I have tried a lot of things tyo program for the IC bridge inspector but it fails everytime, Can someone please help me learn the programming of IC bridge. Thank you
Electronics Forum | Thu Apr 19 20:01:30 EDT 2012 | eadthem
some things to consider, Is there flux on the board. are there finger prints on the tops of parts. Is the board warped at the V score from reflow Is the board shifting in the machine during inspection. These are the issues we have had with our mir
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Fri Aug 07 14:55:41 EDT 2020 | glasscake
Also yes I know about Mirtec's second owner program but it is not an option considering the cost of that is almost as much as it cost to buy the machine. Does anyone have like a developer manual that gives in depth explanation of the functions/tools
winsouce.jpg)
.gif)