Electronics Forum | Fri Dec 21 16:34:28 EST 2012 | bdamico
Hello All, Some of the issues reported in this thread sound similar to those commonly experienced with network delays. A very simple way to determine if this is indeed the case is to run directly off of the system hard drive versus a network hard d
Electronics Forum | Thu Apr 25 13:55:36 EDT 2013 | bdamico
Hello Eadthem, This is very disturbing information. I urge you to contact our technical support center so that we may assist you in resolving these issues. Our contact information is available at http://www.mirtecusa.com. As stated earier, plea
Electronics Forum | Thu Jul 16 08:47:49 EDT 2020 | mcbasol
Hello everyone, I'm in a manufacturing environment with a middle mix of boards, and some mid volume. The cards are our design and the most diffucult pakage is TSSOP-14, QFP-128 and 0603. So, we have deciced to buy Mirtec MS-11 3D. What is your experi
Electronics Forum | Tue Apr 27 11:53:36 EDT 2021 | dontfeedphils
When I was looking at Mirtec (4-5 years ago) I wasn't very impressed compared to Koh Young. It was easy to tell that Koh Young started with 3D and then added 2d features where needed, and that Mirtec had done the opposite. There's nothing wrong wit
Electronics Forum | Sun Oct 26 09:24:17 EDT 2008 | tony_d
Hello Reese, You may want to check out MIRTEC's MV-7 machine. It is simple to use, like your YESTech M1 (we looked at YESTech before selecting MIRTEC). But unlike the M1, the MIRTEC MV-7 has five 2 meg cameras, and a laser inspection option as wel
Electronics Forum | Thu Jan 18 09:11:35 EST 2007 | AR
Hello Chris, Are you inspecting wave soldered boards as well with the Mirtec? I hear that inspecting wave soldered boards is so much more complicated than reflowed boards, no doubt due to the varying shapes of even perfectly acceptable solder joints
Electronics Forum | Thu Jan 18 14:58:52 EST 2007 | jhaviland
Another question. Did you also use the table Mirtec provides for the desktop models? They work horribly on even a slightly unstable table, Which is what I have seen. Very outstanding machines but crippled by an employers choice of using a standa
Electronics Forum | Fri Jan 11 07:26:07 EST 2008 | laplooi
Hi, me again. Who can tell me which software is availble for the Mirtec MV-2BTL? On this moment we working with Mirtec Inspector 3.4.2/7.50+ is this the only software which is availble for the MV-2BTL?
Electronics Forum | Thu Nov 01 02:45:47 EDT 2007 | laplooi
Whe have the Mirtec about 2 years now, the question is, that when you have 100 components to check he give's 20 to 30 failures that no failures are. are there people they have the same problem?
Electronics Forum | Thu Jan 24 21:02:40 EST 2008 | bdamico
Hello Bruno, Please contact our Technical Support Staff at (203) 881-5559. We will be more thatn happy to assist you. Thank you, Brian D'Amico President MIRTEC Corp